PC rated. 1" Diameter, waterproof mini LED amber light functions as a side marker and clearance light when properly mounted. Recessed-mount installation with included grommet. 2-Wire design. 18" Long pigtail.
Features:
Specs:
The waterproof construction of this light makes it ideal for use on trailers that may be submerged, like a boat trailer. The housing and lens are sealed together to create a single unit, which means that water will not get into the light and damage the diode or circuit board.
A PC-rated light produces a 90-degree angle of light to either side of its centerline for a total of 180 degrees of coverage. This beam pattern can be clearly seen when you are standing directly in front of the light, as well as when you are standing on either side of the light. When properly installed, this type of light can function as both a front clearance light and a side marker light or as a rear clearance light and a side marker light.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello, everybody. This is Jeff at etrailer.com. Today, we're gonna take a look at the TecNiq recessed mount, mini amber LED, side marker trailer light. Now, this is a small, round LED light that'll serve as a side marker and clearance light for your trailer. Does use a nice sealed weatherproof housing and lens unit, and it does have an IP 68 rating. Does use the military-grade construction of the circuit board.
Uses urethane potting which offers better protection than the common epoxy potty. The LED is a premium LED. It's energy efficient, long-lasting and vibration resistant. And it is rated for up to 100,000 hours of operation. The lens is a durable UV resistant lens, and it is a clear lens over an amber, one amber LED.
And this is compatible with 12 volt DC system. It is a recessed mount installation. Comes with the included grommet, and it does require a 3/4 inch diameter cut-out for this light to fit into. We do also offer a stainless steel trim ring if you might want a nice finished look on it. We do sell that separately on our website and it is listed on this product page as a related product.
The wire harness on this is a two-wire harness. It'll hardwire to your application. It includes a ground wire and a power wire. The wire length on this is about 18 inches. And this is a PC-rated light, which will produce 180 degree beam when properly installed.
And it does meet or exceed the Federal Motor Vehicle Safety Standards. Now, I am gonna hook this up to some power just to show you how bright it is. But before I do that, I wanna give you some dimensions. The diameter on this is right at one inch. Total depth, front to back is right at 7/8 of an inch. Input voltage, nine volts to 14 volts. And the power draw, .03 to .06 amps. So again, what we're gonna do is we're gonna go ahead and hook up our two wires. And once we got them hooked up here, go ahead and turn on our power. And with the power on, you'll be able to see the amber LED light. So, I'll go ahead and turn off the overhead lights so you get a better view of it, and you can see how bright it is. And it is a clear lens with an amber LED. Go ahead and turn back on our overhead lights. Turn off our power. But that should do it for the review on this TecNiq recessed mount, mini amber LED, side marker trailer light..
Average Customer Rating: 4.7 out of 5 stars (86 Customer Reviews)
PC rated. 1" Diameter, waterproof mini LED amber light functions as a side marker and clearance light when properly mounted. Recessed-mount installation with included grommet. 2-Wire design. 18" Long pigtail.Fast service, very pleased.
a fun little project, I put new tail lights on my trailer and found out I had one bad wire , so I pulled new wires and added these onto my Roller guides , look really nice!
I would definitely recommend purchasing! These are my favorite style of side marker lighting, small but bright.
Would definitely purchase again! These are my favorite style of side marker lighting.
Would definitely purchase again! These are my favorite style of side marker lighting.
These LEDs are an exact match for my SportTrail trailer (custom for a 26' center console). They are MUCH cheaper to purchase from here than direct from SportTrail.
These mounted cleanly in the fenders with in the provided rubber grommets, making them nearly flush with the surface, yet has 180 degrees of light. I wired them into the existing running lights and are BRIGHT, day and especially at night! Now, I can see the where the trailer is when backing. Submersible too, which is a terrific bonus. I discovered that unlike most LED lamps I've used, these must be connected black to positive and white to ground. I did not find this small detail in the description, or the video which shows connecting to two alligator clips which were both black. This needs to be clearer, but overall, ETrailer has done it again, with items we need to keep things usable and safe.
I am happy with how fast it was delivered. But the packing worried me. The small plastic lights were just tossed into the box along with the very heavy trailer hitch. The edge of the box was torn. The heavy metal hitch could have very easily crushed the plastic items. Maybe those could have been placed inside a rolled up paper bag.
But lucking out there was no breakage.
I will review after I install. But I like it. The led light wires are big enough to splice onto other wires.
Consider me happy
I am happy with how fast it was delivered. But the packing worried me. The small plastic lights were just tossed into the box along with the very heavy trailer hitch. The edge of the box was torn. The heavy metal hitch could have very easily crushed the plastic items. Maybe those could have been placed inside a rolled up paper bag.
But lucking out there was no breakage.
I will review after I install. But I like it. The led light wires are big enough to splice onto other wires.
Consider me happy
This works perfect, I'm very happy with this marker light. Thank you.
I replaced a Tail Marker on my flatbed truck. This one was was exactly like the existing lights and matched perfectly.
Great quality product and fast shipping
These little lights are bright and perfect for a 3/4" hole. Easy to install and wire up.
As always Etrailer has a great selection of parts and great service.
I’ve always gotten good service and products from E Trailer
Great product
Parts were as descibed at a great price and arrived in a timely manner.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.