Optronics Mini Red LED Clearance or Side Marker Light - Submersible - 2 Diodes - Clear Lens

Video Transcript for Review of Optronics Trailer Lights - Submersible Red LED Clearance Or Side Marker Light - OPT47WR

Hi everybody. Andy here with etrailer.com. And today, we're gonna take a look at this Optronics submersible, mini red LED clearance or side marker light. With this little oblong waterproof LED trailer light, you are gonna be able to haul safer by alerting other drivers of your trailer's position and direction of travel. As you can see, I already have this connected to 12 volt power. And this light functions as both a clearance and side marker light when properly mounted.

This is how bright it is with my studio lights on. Let me go ahead and turn my lights off to give you a better idea what this is gonna look like, especially at night. Now, these two red LEDs can last 50 times longer than incandescent lights. They're more efficient. They provide brighter light with less power output.

There's no bulbs replace or no brittle filaments. This is a P2 rated light, meaning that it produces a 45 degree angle of light to either side of its center line for a total of 90 degrees of coverage. This beam pattern can be seen straight on, but it cannot be seen clearly from the side, so this type of light can be used as either a side marker light or a clearance light, but it cannot be used as both. So, if you need both a functions, then you must install two separate lights on your trailer. One as a front or rear clearance light, and one as a side marker light.

This light features a sonically sealed, waterproof housing and a lens unit that is submersible. And it has an impact resistant, polycarbonate housing and lens. And the transparent lens help produces a clear, colored light. This is a surface mounted light and surface mounts to your trailer with two number 10 screws. Those screw are not included, so you would have to get that either locally or a separate purchase.

And this is a single wire design that grounds through the mounting hardware. Now, this is compatible with 12 volt DC systems and the power draw at 12 volts is 0.06 amps. Just give you an idea of the size of this light. Looking at the overall length of this light from end to end, we are sitting right at 2 1/2 inches long. And looking at the width, we're sitting right at about an inch and an eighth wide. Line that up here a little bit better for you. And then the thickness, we're sitting right at about five eights of an inch thick. And then the distance between those mounting holes, center to center, line that up here for you, we are sitting right at 1 7/8 inches. Now, there is a lifetime warranty on the two LEDs. And that is going to conclude our look today. I do hope that it was helpful for you. Again, my name is Andy. Thank you for joining me..