Summer Starts Here - Save up to 70%
4-1/4" x 1-11/16" Oval. Waterproof, LED light serves as a clearance or side marker light when properly mounted. Chrome bezel provides finished look. Surface mount to trailer. 2-Wire design with 0.180 male bullets. P2 Rated. Red LEDs
Features:
Specs:
The waterproof construction of this light makes it ideal for use on trailers that may be submerged, like a boat trailer. The circuit board is sealed, which means that water will not damage the diodes or circuit board.
A P2-rated light produces a 45-degree angle of light to either side of its centerline for a total of 90 degrees of coverage. This beam pattern can be seen straight on, but it cannot be seen clearly from the side. So this type of light can be used as either a side marker light or a clearance light, but it cannot function as both. If you need both functions, then you must install 2 separate lights on your trailer - one as a front or rear clearance light and one as a side marker light.
Surface-mount trailer lights install using a flange or bracket with mounting holes. These lights lay flat against the trailer surface and only require a small, often pre-existing hole, for wiring. Mounting hardware is used to secure the light to the trailer.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we're gonna be taking a look at the Optronics Millennium series LED side marker or clearance light. This light is a PT rated, red light that can be used as a side marker or clearance light for your trailer. Features a sealed, waterproof design that is submersible. It has the clear, polycarbonate lens that's very strong and durable. It does come with a chrome bezel that adds a clean finish look to the unit, that simply just snaps over the housing, snaps into place.It is a two wire design with 0.18 male bullet connectors, one for power one for ground. LEDs make great replacement for incandescent light.
They last longer, burn brighter, and they're much more efficient, you don't have to worry about replacing bulbs or worry about brittle filaments. It is department of transportation compliant.A few measurements to go over with you real quick, overall length is about four and one-quarter inches. Going this direction, it's about one and seven-sixteenths of an inch. Overall depth is about three-quarters of an inch, and the mount holes are separated on center by three and one-eighths of an inch. Mounting hardware not included.Power draw at 12.8 volts is 0.033 amps.
Contains a total of three LEDs or three diodes and Optronics puts a lifetime warranty on the LEDs. We're gonna go ahead and hook it up to power, that way you can see what it looks like with some power running to it, and then we'll also be able to turn off our overhead lights so you can see it in a lower lights setting.So you can see here that it sends out a very strong, consistent signal. Again, it's got three LED's that are red in color. The multi diode design really helps optimize the light output, and this would be a great choice to use as a side marker or clearance light for your trailer.That's gonna do it for today's look at the Optronics Millennium Series LED Trailer Light.
Average Customer Rating: 4.9 out of 5 stars (23 Customer Reviews)
4-1/4" x 1-11/16" Oval. Waterproof, LED light serves as a clearance or side marker light when properly mounted. Chrome bezel provides finished look. Surface mount to trailer. 2-Wire design with 0.180 male bullets. P2 Rated. Red LEDsThe side marker lights look very good. They are high quality and well built.
etrailer has been a wonderful resource for me. They generally include videos of the products
installed, which makes things easier to understand
Great product! Just as described and etrailer product specialist are very informative!
This is an excellent product. Top quality!
So much better than lights you buy at your neighborhood auto supply.
Lights up bright with the LED bulbs.
A little higher price than your normal lights but it is well worth the difference.
Highly recommend!
I was wanting the exact light and connector so it would be a easy replacement and it was just what I was looking for Thanks etrailer
Great Service, Good pricing and Quick Delivery. Thanks for locating the proper part for this older Titanium trailer.
Good looking and working product. Chrome cover is plastic but should hold up well.
I had a good experience with these guys. Price was right and ship time was proper.i do t have anything bad to say.
Good cuality
Excellent service
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.