Summer Starts Here - Save up to 70%
To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Perfect for light-duty towing, this custom, vehicle trailer hitch receiver features fully welded, gloss powder coated steel construction. Drawbar sold separately.
Features:
Specs:
At etrailer.com we're committed to the products we sell, and to our customers. Our experienced and knowledgeable staff are available via both phone and email to address your questions and concerns for the lifetime of your hitch. The technicians at etrailer perform hitch installations on a daily basis, making them a valuable resource for do-it-yourselfers. The one-on-one, personal service you'll receive comes straight from an expert in the towing and automotive field. We've installed it, we've wired it and we've towed with it, so whatever your question, we can answer it.
Average Customer Rating: 4.7 out of 5 stars (9 Customer Reviews)
Perfect for light-duty towing, this custom, vehicle trailer hitch receiver features fully welded, gloss powder coated steel construction. Drawbar sold separately.Hitch C11427, Installed on 2008 Toyota Avalon, Installed 2017. Hitch Installation time in my garage 5 plus hours. Requirements: Jack up rear end of car so both rear wheels at least 1 inch of ground, Penetrating spray for rusty bolts and potentially rusty bolt holes, angle grinder to remove 2 weld nut/weld nut brackets retaining the old muffler isolator brackets you will no longer need (and are in the way for new hitch) and to smooth out the original weld, pry bar and lubricating spray to pry off muffler isolators, adjustable strap to support and lower exhaust system once you remove all the exhaust isolators, good to have some large diameter washers on hand in the event when bending the muffler shielding you pull through the existing washers.
Hitch fits great, is well constructed, sits tight up against bumper (about same height as tail pipes so shouldn't bottom out any worse than today) and sits back behind bumper about 2 inches so no issues with banging chins when walk around the car. Great Product.
Quality is good. Installation was tight. It is recessed just a bit too much under the car and my bike rack cannot attach without modification. An extension/ball for a trailer no problem. I would chose this brand again.
The trailer hitch for our 2006 Toyota Avalon arrived quickly and was of good quality. Unfortunately, the instructions that came with it were sorely lacking in detail. It said it would take an hour to put on the hitch but took 4 hours and two people to install. A more complete diagram including the underside of the car and what had to be removed in order to install the hitch would have helped. It was difficult to get at to some of the bolts that had to be removed as they were behind or above the muffler. Unless you pay someone who has installed a hitch on this car before, count on it taking quite a long time and lots of skinned knuckles. In its favor, it looks great once we finished.
Excellent item. Not to difficult to install if you take your time. I have to do the install by my self and I'm over 60 years old. Therefore, I use a floor jack to support the hitch. Once installed it looks great and not unsightly... Thank you for making a great product.
I'm very satisfied with the receiver. You can't do better.
It went on as it should and is very stout. should do the job well.
Do you have a question about this Trailer Hitch?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.