Replacement Mounting Stud for Dexter 5 on 4-1/2 Hub and Drum for Hydraulic Brakes

See what our Experts say about this Dexter Accessories and Parts

• Can Self-Adjusting And Manual-Adjust Brake Assemblies Be Used Together
  Since self-adjusting brakes adjust on their own you'd never get the settings to match between the self-adjusting and manual adjust brake assemblies. This can cause uneven braking which could also throw off your ability to control the trailer and come to a safe stop. This also applies for tandem/triple axle trailers for the same safety reasons. Since the part you're looking at is used on 3,500lb assemblies and you have a single axle trailer I'll assume that's the weight class you'll be...
  view full answer...
• Correct Replacement Wheel Mounting Bolts for a Dexter Hub and Drum Assembly for 3.5K Axles
  The Replacement Mounting Stud for Dexter 5 on 4-1/2 Hub and Drum for Hydraulic Brakes # T0508101 is not going to work with the Dexter Trailer Hub & Drum Assembly for 3,500-lb Axles # 84546UC3-EZ you're looking at as these bolts were meant to replace the bolts on the no longer available Titan 5 on 4-1/2 Hub and Drum T1543900CB042, which uses press in bolts, whereas # 84546UC3-EZ uses drive in bolts. Instead, for the Dexter Trailer Hub & Drum Assembly for 3,500-lb Axles # 84546UC3-EZ you'd...
  view full answer...
• Lug Nut Compatible With Mounting Stud for Titan 5 on 4-1/2 Hub and Drum for Hydraulic Brakes
  If you're looking for a lug nut that goes with this mounting stud # T0508101 it takes a bolt size of 1/2"-20 x 1-5/8". You can get these # 12CLN-L or go with a more basic nut like these # CE11051.
  view full answer...
• Knurl Diameter and Under-Head Length of Titan Replacement Mounting Stud
  I spoke with a contact at Titan, and part # T0508101 has a knurl diameter of 0.561 inches and an under-head length of 1.69 inches.
  view full answer...
• How to Pick out the Correct Replacement Knurled Bolt for a Dexter Braking Assembly
  It's possible, however when replacing knurled bolts it's best to replace the bolt with another knurled bolt. In order to determine which replacement bolts you're going to need, you're going to need to remove one of the bolts and measure the length of the bolt, the knurl diameter, and take note of the bolt size (i.e 1/2"-20). For instance, if you needed a 1/2"-20 x 1-5/8" bolt, with a knurl diameter of .542", then the Replacement Mounting Stud for Dexter 5 on 4-1/2 Hub and Drum for Hydraulic...
  view full answer...

Do you have a question about this Accessories and Part?