etrailer Trailer Hub and Drum Assembly Review and Installation Video

The only differences between the two hubs you mentioned #8-201-9UC3-EZ and #8-201-5UC3-EZ are that the 8-201-5UC3-EZ is not pre-greased and the other is and they have different bearing between the two. But the bearings both have the same inner…

Based on the GVWR of your 2019 Jayco North Point 315RLTS it does seem like you have 7k axles. I recommend verifying this information to be sure. These axles typically use the #14125A outer and #25580 inner bearing found in the Timken #TMK92VR.…

I can certainly point you in the right direction. This will be a tricky one, as the Dexter 5,200 lb axles can use more than one seal size. We do not have the ability to pull an OEM build sheets to see what parts they installed at the factory so we…

The Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles - 8 on 6-1/2 - 9/16" Studs #8-219-13UC3 will fit on your Lippert axle. They use the same size bearings and seal.

It does! I checked with Lippert for you and the exact replacement that matches up with your 814202 hub is the part number you listed: - Easy Grease Trailer Hub and Drum Assembly for 6K Axles #AKHD-655-6-G-EZ-K

If it feels like the hubs are getting too hot, one item to check is if the spindle nut is too tight and the added stress on the bearings is overheating the bearings and hub that could cause damage to the bearings. I have attached a video of our…

You can absolutely upgrade your manual electric trailer brake assemblies on your tandem axle trailer to self-adjusting brakes like the 10 inch #AKEBRK-35-SA or the 12 inch #AKEBRK-7-SA. As long as the assemblies on each axle match you can update your…

If you have grease coming out the rear seal, you have a bad seal or the incorrect size seal size. The EZ lube spindles will allow you to see grease out the front with the rear seal intact if your seals are working properly as you stated. I've…

Any grease on the back of the wheel could be from the grease working its way out from having slightly too much or it could be from a grease cap or grease seal that is not fitting properly. The grease cap and seal should be keeping any excessive…

Dexter hub drum assembly #8-219-13UC3 is a replacement for your hub drum according to my contact at Redneck Trailer Supply. This is rated for 7K, has a 8-on-6-1/2 bolt pattern and 9/16-inch studs. You can also identify compatible replacement…

In order to select a correct replacement hub for the damaged unit on your Jayco 5th Wheel trailer you will need to match several identifiers from the original. First, you will want to note the axle capacity, which is usually found on a sticker or…

We don't have that exact part number but for basically the exact same hub except made by Dexter you'd want the part #8-219-13UC3. This is the sam 6k-7.2k hub with an 8 on 6-1/2 inch bolt pattern that uses 9/16 inch studs just like the one you…