RackEm Spare Tire Carrier Review Video

We have seen people mount storage boxes on either side of the nose of a V-nose trailer like what you see in the picture I attached. The part #DZ91717P would work well if you have room for it like that. The dimensions of the box are 36"…

For the 6-point Level-Up System by Lippert, I made a call to the manufacturer to ensure you would receive correct information. Lippert said that when you bolt the footpads to the jacks, you need to torque them to 132 ft-lb. They said to make sure…

Due to the importance of a properly functioning break away system, it would be best to leave the existing break away battery in place and add an additional battery for powering the jack. A standard automotive or small deep-cycle 12 volt battery…

The E Track Spare Tire Carrier part #RA-16HST that you referenced would be what you need. It will attach to horizontal E-track like what you have. I attached a picture of it being used in horizontal E-track on a trailer wall like yours.

I actually have a better solution for you than using #3057-55. You could instead use #PLR458-018 and then supply your own pipe. That way you can get as heavy as a pipe that the system will allow. Or a solid bar for that matter. The pipes on the…

For your Karavan trailer I recommend LED tail lights #STL57RB and #STL56RB. They are a little shorter at 6-1/16 inches but they do mount on studs spaced 2 inches apart on center. they are 3-5/8 inches tall and 2-1/4 inches deep overall. I have linked…

We have a couple different options available for a spare tire mount inside your cargo trailer. - Rack'Em Spare Tire Rack for Enclosed Trailers #RA-16, this includes (1) spare tire holder but has the ability to hold additional tires with the…

Aluminum is a pretty soft metal. Especially as thin as you mentioned. I wouldn't recommend self tappers for the e-track. Instead I would recommend appropriately sized nuts and bolts on either side of the track with larger washers.

Yes, the SureCall Fusion2Go 3.0 RV Cell Phone Signal Booster #SC43MR will need to be registered with your mobile provider before the first use.

Thanks for the pictures! I have exactly what you are looking for. We have a couple of mounting options for the control knob that can go inside inserts in your Subaru's dash. This will give you a clean factory look install. The Universal Mounting…

If the leaf spring stack is currently attached below the axle, which is what it sounds like, then you can use an over/under conversion kit. If the axle is 3 inches in diameter then you can use #K71-385-00. If the axle is 2-3/8 inches in diameter use…

The width of the Optronics Flexible LED Light Strip #UCL90CB is about 3/8". I have attached a review video where we take this measurement for you to check out. To help remove the 3M adhesive I recommend using some heat like a hair dryer or…