Polar Cam-Action Latch Kit Replacement Hasp Review and Installation Video

To replace the 160019 touchpad you'd need the #LC421484 but we do not have the other parts you mentioned.

To replace the Level Up controller on your 2012 Dutchmen Infinity 3750FL you need the Replacement OneControl Advantage Controller #LC88TF. I confirmed this is what you're needing with my contact at Lippert!

To clear an error from the Control Panel for Lippert Ground Control #LC421484 you must repair the error and simply press the enter key on the control panel. If the same message is still displayed the error has not been repaired. If you can tell me…

It sounds like you're looking for the Replacement Quick Level Touch Panel for Lippert Components Level-Up Hydraulic Leveling System #LC74FR which works with the Level-Up system. This is the touch pad "controller" but if you…

It's likely you have a blown fuse. There should be a 15 amp fuse that runs to the remote part #LC421484 as well as 35 amp fuses in the control module. Verify that all of the fuses are good as typically this is a blown fuses scenario.

Yes, the Replacement Control Panel for Lippert Components Leveling System part #LC421484 has replaced the Replacement Auto Level Control Panel for Lippert Ground Control Leveling System part LC234802 and is what you need for your 2016 Keystone Raptor…

For the etrailer D-Ring Tie Down Anchor #RRING-Q6000 you will need to use the Backing Plate #BP05. This will increase surface area for the bolts used to attach the anchor to your floor giving it additional support. I included a video of the…

The #BUL69CB LED Utility Light Bar you mentioned can be used for utility use or general illumination, but is not certified by the DOT for use as a back-up lamp as it would be too bright.

We do have LED 1076 bulbs like with the #DI95VR for a cool white or the part #DI45VR for warm white.

We offer two Paneloc lock hasps that are 1-1/2-inches wide, parts #H145-203E and #H135-203E, both of which are shown on the linked page. We also offer cam door latches like 2-inch #PLR158-102-A and #PLR158-102-SS, as well as 1-inch hasps like…

Grease Cap set #RG04-040 are regular grease caps that have a rubber plug on the end to access a grease zerk fitting on the spindle (end of the axle). They install the same as regular grease caps. It sounds like you are looking for bearing protectors…

I'm going to have to recommend replacing the entire breakaway switch as I cannot locate any replacement parts for your Tap by Hoppy switch. I recommend the Tekonsha Trailer Breakaway Switch #420000 for a replacement. The wiring is long enough to…