Polar Hardware Lock Side-Door Bar Lock Assembly Review and Installation Video

There is not a direct replacement for your series 6300A model 6325 power converter. The 25 amp converter with 12V power can be replaced with the Progressive Dynamics Inteli-Power RV Converter and Battery Charger - 12V - 30 Amps #PD9130 which will…

The Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp #PD4645V is a replacement for your converter. It will work very well based on the cross-referencing for a perfect fit. All converters have a battery charging system…

If you have the Magnetek Power converter, Series 6300 Model 6325, there is not a direct replacement available, most choose to upgrade the entire system at this point. I suggest the Progressive Dynamics RV Power Control Center with AC/DC Panel and…

You can't get a larger ball for the Rack'Em Trailer Dolly part #RA20, but the good news is that you don't need one to use it with a trailer trailer that has a coupler designed for a 2-5/16 inch hitch ball. The reason for this…

Installing the Hinges on your Side-Door Bar Lock Assembly, item #305736, is pretty much up to you and the construction of your trailer. You will need to purchase appropriate hardware to install the Side-Door Bar Lock that you purchased. It is best…

90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.

I think you are going in the right direction. I would definitely replace the 14 gauge wire going to the trailer brake magnets with 10 gauge wire or larger. Usually larger than 10 gauge is hard to get into the trailer connector though. I would also…

From the pictures you sent in, it looks like the hinge assembly itself rusted through and ripped off. It seems like it may have been fabricated by the previous owner. That latch style is usually accompanied with a bar like with the Cam-Action…

A standard trailer dolly like #RA20 is not directly compatible with the Lock N Roll hitch system. There is not a dolly designed to work with that system, however if you were to use a similar system with the ability to attach to a hitch ball, then a…

If your trailer has a 2-inch ball coupler you can still use the 1-7/8-inch Rack'Em Trailer Dolly #RA20 to move it to and from your storage position. While it would not be appropriate to tow with different sizes of ball and coupler use of a…

We don't sell a 2-5/16 inch hitch ball with a 3/4 inch shank, but since a tow dolly is only used for small trailer movements across a parking lot your current hitch ball should work just fine. When using a tow dolly the tongue weight alone of…

For a travel trailer weighing 4,500 pounds, I recommend going with the Trailer Valet XL Trailer Dolly #TVXL2. The Trailer Valet XL is going to offer much better support for the tongue weight of your trailer than a standard trailer dolly. The…