Review of Lippert Components Trailer Camper Jack - Replacement Control Unit - LC421484 Video

Based on the parts diagram from Winnebago your 2013 Itasca Suncruiser 32H will use the Lippert Replacement 500:1 Motor for Electric In-Wall RV Slide-Out System #LC287298.

To replace the 160019 touchpad you'd need the #LC421484 but we do not have the other parts you mentioned.

The Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System part #LC421484 replaced the LC234802. It may look a bit different but it will still work great in its place.

To clear an error from the Control Panel for Lippert Ground Control #LC421484 you must repair the error and simply press the enter key on the control panel. If the same message is still displayed the error has not been repaired. If you can tell me…

It sounds like you're looking for the Replacement Quick Level Touch Panel for Lippert Components Level-Up Hydraulic Leveling System #LC74FR which works with the Level-Up system. This is the touch pad "controller" but if you…

It sounds like it yes but first, I recommend unplugging it from power and let it sit for about 15 minutes. This is going to hard reset the panel and hopefully fix the issues. You're going to also want to make sure that the connectors are clean…

Yes, the Replacement Control Panel for Lippert Components Leveling System part #LC421484 has replaced the Replacement Auto Level Control Panel for Lippert Ground Control Leveling System part LC234802 and is what you need for your 2016 Keystone Raptor…

When you plug in the Lippert Replacement Control Panel #LC421484 it will immediately recognize the connected controller board. This part does not need to be programmed; it is plug-and-play, which was confirmed by Lippert. In a separate link I have…

If you have the Lippert Ground Control Leveling system on your trailer the correct replacement module/display is the part #LC421484. Feel free to email me back with the pictures you have and I'll take a look though.

The Replacement Auto Level Control Panel for Lippert Ground Control Leveling System part #LC421484 is just a newer version than the one you have now and can be used as a direct replacement. I was able to confirm this with my contact at Lippert.

It's likely you have a blown fuse. There should be a 15 amp fuse that runs to the remote part #LC421484 as well as 35 amp fuses in the control module. Verify that all of the fuses are good as typically this is a blown fuses scenario.

The Lippert Replacement 500:1 Motor for Electric In-Wall RV Slide-Out System, #LC287298 is the proper replacement part for Winnebago PN 181862-01-700 and is considered a high torque replacement motor. If your 2014 Itasca Solei 38R was built with the…