Troubleshooting Lippert Ground Control with Zero Power

Question

Question:

I am getting zero power to the unit. Will not turn on. The camper battery is fine. The camper has been stored for about 6 months. It was working fine before this.

asked by: Walter K

0

Expert Reply:

It's likely you have a blown fuse. There should be a 15 amp fuse that runs to the remote part # LC421484 as well as 35 amp fuses in the control module. Verify that all of the fuses are good as typically this is a blown fuses scenario.

expert reply by: Jameson C

0

Answer 1

The blank screen on your LCI Ground Control 3.0 could be either a power issue or a control module issue. I recommend first remove the panel and unplug it from the back leaving it unplugged for at least 15 minutes so that it loses all of the residual…

view full answer...

Answer 2

Sounds like the panel is active but the display isn't working. You've done about everything you could to reset it so you'd need to replace the panel with the part #LC421484 that you referenced.

view full answer...

Answer 3

I have attached the owner's manual for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part #LC675817 to this answer page for you. The one we have on file does not have 43 pages and I am not familiar with one that does.…

view full answer...

Answer 4

I reached out to my contact at Lippert and they said that it sounds like you just aren't holding the 4 buttons for the reset long enough. It requires 5 seconds, but many people will count to 5 a little too fast and the system won't reset. He…

view full answer...

Answer 5

It sounds like you have a control module issue if the Lippert leveling system isn't working consistently with the remote functions. If you can find the control panel for the unit behind it there is the control module part #LC304136. Try…

view full answer...

Answer 6

The good news is your system is working. That lets us rule out 2 of the 3 possible components. Before replacing the third one, I recommend unplugging the connections on the panel and cleaning them prior to reconnecting. If this doesn't solve your…

view full answer...

Answer 7

If your Lippert Ground Control panel is lit up but not showing anything on the screen I'd first try unplugging it and plugging it back in to see if that clears out any internal errors. If that does not fix the issue the panel would need to be…

view full answer...

Answer 8

More than likely the issue is going to be the control panel. There are a couple of things you can try before replacing your current panel though. The first thing you can do is to make sure that all of the connections on the back are solid and then…

view full answer...

Answer 9

We have heard of this issue before on the Lippert Ground Control systems #LC358590. Here is the recommended procedure for clearing the error code: Extend all jacks at least 6 inches. Then press and hold the RETRACT button until the jacks begin…

view full answer...

Answer 10

I recommend disconnecting 12V electrical power from the main system control panel for a few minutes. Usually about 15-minutes without power does it. Once reconnected to power if you still have error codes, such as "Out-of-Stroke", to clear…

view full answer...

Answer 11

Typically when the "Auto Level Failure" error appears it's either a result of the trailer being on uneven ground or the Zero Point simply needs to be reset. If you find that the trailer is on unlevel ground simply move it to a different…

view full answer...

Answer 12

Sometimes the displays of the Lippert ground control systems need to be reset. Try unplugging the control panel for several seconds and then plugging it back in. We've seen just doing that alone fix most of the problems with the control panels.

view full answer...

Troubleshooting Lippert Ground Control with Zero Power

Product Page this Question was Asked From

Continue Researching