Master Lock Hitch Locks - Standard Pin Lock - 3794DAT Review 3794DAT Video

We only have replacement springs and latches for the Bulldog Collar Lok couplers. We do not have the lower piece it sounds like you are looking for. You would need to replace the entire coupler. The part #BD028288 would work well as a replacement…

Yes, if you wanted to weld on the Demco coupler part #DM37ZR instead of bolting it on you certainly could. This is powdercoated though so you will need to remove the powdercoating first. For a similar coupler that was designed to be welded on and…

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

Since you are looking to lock your trailer when connected as well as when disconnected, I recommend the Master Lock Trailer Hitch Receiver Lock and Coupler Lock Set - 1-1/4" and 2" Hitches #3794DAT. This kit will give you a hitch…

The TowSmart Trailer Coupler Lock Kit - 1-7/8, 2, and 2-5/16 Couplers w/ Hitch Lock & Coupler Lock #TS84FR uses different lock cores/keys for different kits. Although they are not 100% unique, the odds that someone would order the same lock…

We recommend using 2 of the Ultra-Fab Chock and Lock Wheel Stabilizer #UF21-001060 when your trailer is parked as that will keep it more stable on both sides. You can find a kit of 2 with part #UF21-001070. Please note that you also need to add the…

BTR and BT8 are the reference numbers for a standard trailer spindle size. When picking out a hub for a trailer you have to make sure that the hub is designed to fit the spindle. What you will need to do is measure spindles on your trailer where…

The trailer hub part #AKIHUB-440-2-1K matches exactly what you would need. Bearings, bolt pattern and stud dimensions are the exact same.

Trailer hub #AKIHUB-440-2-1K does use L44643 bearings which are associated with the BT8 spindle which is a straight spindle, 0.99 inches diameter, where the bearings ride. But the seal inner diameter is 1.249 inches. Check the bearing numbers on…

In general the etrailer.com hubs like part #AKIHUB-440-2-1K cost a bit less than the Dexter hub equivalents but offer the same fit and performance. We just get them at a better price so we can pass the savings on to you. Since your spindle has…

Personally I prefer the Curt Trailer Hitch Receiver #C11158 over the Draw-Tite #24872 as the Curt is made in the USA. Both these are Class I receivers with a capacity up to 2,000lbs of trailer weight and 200lbs of tongue weight. Be sure to verify the…

The usable span of the Bolt Hitch Lock part #BL7023585 that you referenced is a little over 3-1/2 inches. If you check out the picture I attached you'll see all of the dimensions of the lock. This lock is intended for use with 2-1/2 inch hitches…