Review of etrailer Trailer Leaf Spring Suspension - 4 Leaf Double Eye Spring 4000 lbs Axle - e22YR Video

The slight gap you see is normal. The drum is not supposed to make contact with the brake mounting plate. There are some instances when mixing brands of brakes, hubs, and axles, that won't line up properly but in this case it is normal. I did…

We do have a spring that will be a suitable replacement for your 708-no500 leaf spring. Our springs will be 26" eye to eye, but a 1/4" difference will not effect anything and will be completely fine to use as a replacement. We have them…

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

Both your axles will use the same Grease Seal #58846. I am going to list all the common replacement parts for each axle so that you have that information. 4,400lb Axle Inner Bearing #L68149 Outer Bearing #LM67048 Inner Race #L68111 Outer Race…

I definitely recommend replacing your 3,500 lb 26 inch leaf springs with the 26 inch 4-Leaf Double-Eye Spring for 4,000-lb Trailer Axles #e22YR. The 4,500 lb would be too stiff and your ride would suffer so the better option by far are the 4k…

I can certainly point you in the right direction. Unfortunately we do not have access to Dexter's serial number database, and I cannot recommend springs based off of axle specs. If only it were so easy right? The best way to go about replacing…

A 4,000 lb rated axle leaf spring like the part #e22YR would be a great option for your 2021 Keystone 26RB travel trailer. It would give you a little more capacity to help with the additional support you need on the one side of the trailer. It would…

The Moryde wet bolts #MR52HR use a standard 1/4"-28 thread for the zerk fittings.

Typically a suspension bolt will be measured by the shaft of the bolt not including the head, since the head of the bolt isn't used in mounting the springs. The shackles are 3-3/4" long x 1-1/2" tall overall and the bolt holes are…

Yes, the Grease Seals 10-36 part #RG06-070 are a direct replacement for the Dexter 010-036-00.

In the attached diagram the A measurement is actually the distance from the center of the spring hangers for a single axle trailer. The spring eye to spring eye measurement for your leaf springs will be slightly different. The B measurement that you…

As long as both the axles and slipper springs are appropriately rated for the planned loaded weight of your trailer, there's no problem with using slipper springs instead of double-eye models. Slipper springs are actually typically used for more…