DeeMaxx Stainless Steel Drive-In Grease Cap Review Video

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

Powder coating is widely considered to be superior to acrylic paint in terms of resistance to chipping, scratching, and color retention. For a wheel application powder coat will definitely look better as well as hold up better than paint. Based on…

For a wheel that is 5 inches in width and 15 inches in diameter you would want tires that are size ST205/75-15. For the tire size ST225/75R15 you listed you would want a rim that is from 6-7 inches in width. I attached a department page that has all…

I reached out to the manufacturer of the Detail K2 Mighty Multi A-Frame Utility Trailer #K2MMT5X7 and if you have a VIN that begins with L1 then you will use the Trailer Idler Hub Assembly for 2,000-lb Axles - 8" to 12" Wheels - 5 on 4-1/2…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

The seal we offer part #RG06-050 cross references as the same thing as a Transcom part #171255TB. It would be the exact same as what you have/need.

It's not needed to glue the bunk board carpet like #CE11349 as well as staple it. With just staples you'd be fine.

The Dexter Trailer Hub Assembly you referenced, part #AKIHUB-440-2-1K is known as an idler hub. An idler is a hub that is no provisions for trailer brakes. It has no brake drum. Part #8-276-5 is an example of a hub/ drum that has a brake drum that…

To answer your question...yes, you can rip off the zerk fittings of your spindles so that you could install Bearing Buddies. But you should note that Bearing Buddies commonly allow people to overfill their hubs with grease which then turns into a…

Based on the measurements you provided the Grease Seal #010-180-00 is the closest match we have for you in our inventory. We do not carry and did not see the part number referenced KOK 2611 in searches. To be sure you can always revisit your spindle…

Based on the measurements you gave me it sounds like Grease Seal #168233 that you referenced is the one you need. It's a double lip grease seal that has an Inner diameter of 1.688" and an Outer diameter of 2.332". The #010-180-00 seal…

The difference between the ID of the seal and the diameter of the seal riding surface on your spindle, although a VERY small amount, is large enough so the seal will not be compatible. This assumes that the 1.87 inch diameter of the spindle you had…