Ventline RV Vents and Fans - Range Hood Vent - V2111-03 Review Video

Hey Duke, the Ventline Pinnacle RV Range Hood part #VE33SR that you referenced will draw up to 5 amps at 12 volts.

There are two different incandescent bulbs used in the Bargman 84/85 Series Triple Tail Light #30-85-002, the double filament 2057 and the single filament 1156. We do not offer LED equivalents for the 2057 bulb type but we do for the 1156, part…

Since there is not an exact replacement for the Reflect-o-Lite Model #1400 lights you have on your 1989 Toyota Sunrader Motorhome you will need to modify or add a housing to make a different light fit. Since the #47-84-103 is an LED light you may…

The model and serial number of your vent will be marked with a sticker or stamped on the upper side. Basically open the vent and look down in from the top. It may also be located on the bottom and visible when the screen is removed. If this is not…

If freezing is a major concern for you, which it sounds like it is; then I have a better solution for you. The Furrion RV Tankless Water Heater #FR98SR you were looking at operates effortlessly in temperatures as low as 39 degrees Fahrenheit. With…

What you are looking for is the Blue Ox Hitch Receiver Immobilizer II - 2" Hitches #BX88224. This will keep the carrier from moving vertically and horizontally. I've attached a video review to show how. If you have a 2-1/2 inch receiver,…

All of our current outside vent cover for RV range hood options are 11-1/2 inches by 5-1/2 inches outside dimension so they are a little wider than what you described. They fit a rough opening that is 10-1/2 inches wide by 3-3/4 inches. I've…

The Clevis hook part #6495-401-04 that you referenced is standard enough size that it would work well on the hitch of your 2017 Ford F-250. I attached a picture for you to check out that shows the dimensions of the opening. The post that fits through…

Sounds like you are asking about the collar depth of the Ventline Exterior Wall Vent for RV Range Hood #V2111-55. This dimesnion is 1-3/4 inches.

Slide out motors in RVs are powered by 12 volt DC power sources like the part #LC236575 that you referenced and the #LC130057.

The Furrion Over the Range RV Convection Microwave #FMCM15SS that you referenced does not need to vent outside of the RV. It vents back into the RV and recirculates. So no hole is required to be cut into the RV.

When it comes to your 10,000 capacity trailer I recommend the Buyers Products Trailer Safety Chains #337B03822SC. They're made out of a zinc-coated steel. They're 22 inches long and the link diameter is 3/8 inches. I attached a review video…