Review of Redline Trailer Brakes - Magnet Retainer Clips - BP19-001 Video

The 12-1/4" x 3-3/8" Electric Brake Shoe/Lining RH #BP04-255 and Left Hand #BP04-245 are a fit for the Dexter cast backing plate. The Dexter brand is 12-1/4" x 3-3/8" Electric Brake Shoe Lining--Right Hand…

I spoke with my contact at Redline about the availability of the retaining clip for the Dexter 7-inch brake magnets. He said you can use the Magnet Retainer Clip, part #BP19-001 , on the Dexter 7-inch round magnets. These retaining clips will work…

The way you described wiring the electric brakes on your fifth wheel trailer is not only worth a try, it's the way it should be done. If I'm understanding correctly you want to wire from the junction box to the brakes and ground the…

The brake magnet is held onto an electric braking assembly with a clip. It is not impossible for these to work themselves out over time so I would make sure that you still have the clip in place. The clip is located inside the center of the magnet…

You are correct, you should only be getting output when the brake is applied, or the override switch is activated. It sounds like the controller might be bad, but to make sure, you should probably bench test it before tossing it. Use a circuit…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…