Recommended Replacement Brake Shoe Kits for Dexter 12-1/4 x 3-3/8 Inch Electric Brakes  

Sounds like you are trying to add trailer brakes to a trailer that currently does not have any installed. I attached a help article that will walk you through the entire process, but basically you will need to first determine what spindle you have on…

A Dexter 8k hub would have an 8 on 6-1/2 inch bolt pattern like what the part #TA45ZR has. This is also a 17.5 inch diameter trailer wheel. For a mod style wheel instead, we have the part #TA35ZR.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

I spoke to Dexter and they said there is a bit of a process for installing the spindle nut properly. 1. You will need to thread on the inner nut, rotate the hub, then tighten the nut to 100 foot pounds. 2. Loosen the nut to remove the torque, making…

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

Depending on how the trailer was made, there will be a few spots you can check to identify the axle. First, if the trailer was pre-made by a specific company, you may be able to find this information in either the paperwork or on a placard somewhere…

Your air bag mounting location will determine compatibility with the Gooseneck trailer hitch #BWGNRK1313. The side plates of the gooseneck trailer hitch #BWGNRK1313 will mount on the outside of each frame rail. See diagram to the right and video…

You're correct. The repalcement for your existing B12EA-22 brake would be #AKEBRK-7R-SA for the right side and #AKEBRK-7L-SA for the left.

Hi Ken; I reached out to Lippert on this and they were unable to find the specific pressure from the #LC689052 testing. It is a large company and sometimes information gets lost across it with other brands like the Flow Max. I would say the pump is…