Redline Tie Down Anchors TFX250ACQ Review Video

It would be a good idea to go with different holes for the reinstallation of the deck boards on your trailer, or at least enlarge the ones you have and then go with the next thicker screws so that you know you are getting a good grip on the metal…

I would recommend to use the treated torx screws for ACQ (Alkaline Copper Quaternary) treated wood for better corrosion and rust resistance. The treated torx screws like the Redline 2-1/2 Inch Long Torx Trailer Screw for ACQ Treated Wood, part…

We have an option for you, though it isn't recommended to use the 2-1/2" Long Torx Floor Screws #TF01250 with treated wood as it can corrode the non-treated screws. Instead, the best option is the 2-1/2" Long Torx Trailer…

You are correct. The pilot hole size for the Torx Floor Screws, part #TF01250, is 7/32 inch. These come with 40 screws in the package, and measure 2-1/2 inches long. The screwdriver bit you may want for the Torx screws is part #TX430-1. These are…

Since a 2x6 board is about 1-1/2 inches thick, I don't think using 1-1/2" Long Torx Trailer Floor and Wall Liner Screw for ACQ Treated Wood #TFX150ACQ is going to provide sufficient contact with the trailer frame. For that reason I…

The 2-1/2" Long Torx Trailer Floor and Wall Liner Screw #TFX250ACQ is sold individually and not by the box. So you would just need to purchase however many you are needing.

Trailer tires should be inflated when they are cold and should be inflated to the max psi rating on the sidewall. In your case you would want to run 80 psi. If you don't inflate them to the max psi figure you will lose weight capacity and…

The number of plies a tire has no longer has a direct correlation to the weight capacity of a tire as manufacturers have begun to use stronger material which means fewer plies and a higher weight capacity. The figure that is now used instead of…

The 2-1/2" Long Torx Trailer Floor and Wall Liner Screw for ACQ Treated Wood #TFX250ACQ is not the same screw that comes in the package of 40, which is part #TF01250. The 40 screws in #TF01250 are not designed specifically for use on ACQ…

One main difference between LED lights and incandescents is the amount of power each one draws. I did a little research and found that if you were to have LEDs and incandescents on the same circuit, it would be too much power draw for the LEDs…

I spoke with one of my contacts at Taskmaster. I was advised that wheels like the 17-1/2 inch Taskmaster Steel Dual Wheel #1750275WD4 can use any lug nut on them as long as they are flanged.

The 6-lug 15-inch trailer wheels we offer are all the 15 x 6-inch size; please see the linked page. This wheel size can accept tire sizes 205/75-15, 225/75-15 and 7.00-15LT. Our range of these tire sizes is shown on the other linked page. We have…