Optronics Trailer Lights - Tail Lights - RVSTL0061 Review Video

We have some suspension enhancement that fits your 2012 Honda Pilot with the Timbren kit part #THROD2 but we do not have any air bag fits we can recommend at this time. Air bag kits aren't available for all vehicles unfortunately.

Using a hitch extender is safe as long as you stay within the limits specified of 50 percent of the hitch and vehicle load capacity, and 350 lb tongue weight capacity of part #HE06. The other option to provide additional clearance from your spare…

It sounds like your current lights with 2 wires ground to the trailer by the mounting hardware. The One LED RV Passenger Tail Light #RVSTL0060 has three wires, the white wire is the ground, the black wire is the taillight and the green wire is for…

Thank you for all of that excellent information and photos! To replace the front equalizer you need the Curved Equalizer #TREQ104 and then for the rear equalizer you need the Equalizer for 1-3/4" Wide Double-Eye Springs #TREQ105. To replace your…

It appears that your 2006 Keystone Raptor 3612 5th Wheel Toy Hauler has an axle spacing of 33" and uses the 5-3/4" wide short equalizer. I do recommend confirming this as if the suspension has been modified in the last 16 years by a…

The Keystone Carbon 417 should have a 35" axle spread which can be confirmed by measuring from the center of each axle. In which case, we have options from both Dexter and MORryde. The MORryde Rubber Equalizers for Triple Axle Trailers part…

On a towing setup you are always limited by the lowest rated component as the overall towing capacity since that is the weakest point. When it comes to trailer tires you always want to have them inflated to their max psi when cold. Not only do you…

It sounds like you're needing a Bargman 92/94 series taillight. The DOT number you provided usually doesn't steer us to a replacement lamp, the actual part number of your lamps should be printed or stamped on the lamp housings themselves, not…

To determine the correct wiring for your trailer you will need to use a circuit tester, item #PTW2993, and attach the wires from the connector by function only. The light wires should be as follows, red is the stop turn wire and the black is the…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

A trailer light with 3 wires, like #RVSTL0060, that are black, white, and green generally the black wire is for running lights, green is for stop and turn signal, and white is for ground. If the old light on your trailer only used 2 wires, then it…

It sounds like you are looking for the RV Tail Light part #RVST61 which has the integrated license plate mounting bracket you are looking for. Please note, the bracket is part of the light so they must be replaced together.