Replacement Driver Taillight for a Forest River Flagstaff MAC Pop Up

Question

Question:

I was wondering if you carry license plate mounting brackets for behind the left tail light on a 2015 flagstaff Mac pop up camper

asked by: Michael M

0

Expert Reply:

It sounds like you are looking for the RV Tail Light part # RVST61 which has the integrated license plate mounting bracket you are looking for. Please note, the bracket is part of the light so they must be replaced together.

expert reply by: Conner L

0

click to enlarge

Answer 1

We do offer parts like Baggage Door Slam Latches #295-000015 a well as lock and key parts but I am sorry but we do not sell trailer-specific parts such as a front compartment door. You'll need to get that for your Flagstaff from Forest River.…

view full answer...

Answer 2

For your Optronics light part as2t216 we have found that the correct replacement lens is the part #AST60B. Normally the SAE number isn't a reliable way to find lens replacements as it's not a part number but we do know that this SAE…

view full answer...

Answer 3

To determine the correct wiring for your trailer you will need to use a circuit tester, item #PTW2993, and attach the wires from the connector by function only. The light wires should be as follows, red is the stop turn wire and the black is the…

view full answer...

Answer 4

It sounds like your current lights with 2 wires ground to the trailer by the mounting hardware. The One LED RV Passenger Tail Light #RVSTL0060 has three wires, the white wire is the ground, the black wire is the taillight and the green wire is for…

view full answer...

Answer 5

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 6

Your best bet would be to attach something to the tail light housing on the driver side. It looks like perhaps the zip ties in the second picture could have been used to hold a license plate at some point? You might be able to use the existing holes,…

view full answer...

Answer 7

To determine a replacement for your Dometic Duo-Therm units you'll first need to remove the air distribution box cover and determine the connection type, whether it's a 6 or 9-pin connector or if it's hardwired. Next you'll want to…

view full answer...

Answer 8

Both of the ARK stabilizer jacks #ARK94FR and #ARK87FR can rotate 90 degrees forward and back so in a way it is 180 degrees like you asked about. The difference is the #ARK94FR has a square tube and #ARK87FR has a round tube. These are both going be…

view full answer...

Answer 9

I reached out to my contact at Demco who was able to supply me with the attached dimensional photo of the Demco A-Frame Trailer Coupler #DM14793-95.

view full answer...

Answer 10

I called Lippert and they informed me of the grease seal dimensions for your 3,500 lb axle. The correct replacement grease seal for you is part #168255TB.

view full answer...

Answer 11

We do indeed carry Optronics products. The number you provided is a DOT reference number, and does not denote the part number of the lamp or the lens. However we had a picture sent in once from a guy of the housing of the light he needed a lens for…

view full answer...

Replacement Driver Taillight for a Forest River Flagstaff MAC Pop Up

Product Page this Question was Asked From

Continue Researching