Customers compare AL91AB to these similar products
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The Timbren Axle-Less Trailer Suspension System #ASR2000S01 doesn't come with brake mounting flanges and although you can upgrade them at a later time, it would be more cost-effective in the long run to go with the system #ASR2000S02 instead…
view full answer...In order to know what bearing kit you need, I need some bearing numbers from you or some spindle measurements. When you remove one of your hubs, you will find an outer bearing, an inner bearing, and a grease or oil seal. There are numbers printed on…
view full answer...When using an idler hub or a hub and drum with brakes on the Timbren Axle-Less Trailer Suspension System, part #ASR2000S02, the difference in the distance from the bracket to the front face of the hub as shown in the attached drawing would be the…
view full answer...After you plug the 4-way in from your 2006 Ford E-350 to the Curt Trailer Connector Adapter #C57102 you will need to run the rest of the wires as follows: The white wire will need to be grounded to a clean metal surface. The blue wire will go to the…
view full answer...I may have an option for you, but unfortunately the numbers and letters you provided from the bar light on the back of your 2004 Dream Coach Horse Trailer did not cross reference to any lights. Instead we will need to determine the correct light…
view full answer...I pulled up a couple pictures of a 2006 8000HD trailer by Snowbear and it looks like the correct taillight you would need is the #ST9RB.
view full answer...Yes, the OptiMate Portable Solar Panel with Controller #MA96JR that you referenced is compatible with AGM deep cycle batteries like you have.
view full answer...Thanks for reaching out! You will be able to place the OptiMate Portable Solar Panel with Controller #MA66JR up to 140" (about 11-1/2') from the battery bank on your RV if you have the cords stretched out all of the way. This isn't…
view full answer...I can't see any part numbers or manufacturer names from your picture, but the Fulton XLT #F141132 does look very similar. I went out to the warehouse and measured the bracket that the bolt, washer, and nut go through for the installation. The…
view full answer...Without knowing the part number and manufacturer of your current trailer jack, I couldn't speak to the compatibility of the mounting plate for your current jack with the mount that the Fulton #F141132 XLT uses. The #P9012-00 weld-on mount for the…
view full answer...Yes, the Fulton XLT Bolt-Thru Swivel Trailer Jack #F141132 that you referenced is designed to fit the same style of mounting bracket that you have in the picture you submitted. This jack will bolt right up.
view full answer...The inner diameter of bearing #L44649 is 1.063 inches. The inner diameter of bearing #L68149 is 1.378 inches. Both fit on a #84 spindle. The matching race for bearing L44649 is #L44610. And the matching race for bearing L68149 is #L68111. These…
view full answer...