Review of MORryde Trailer Leaf Spring Suspension - Spring Mounting Hardware - MR76ZR Video

Hey Jaime, yes you can replace your 25-1/4 inch 3,500 lb axle leaf springs with a 5k rated axle spring like the part #e44SR. This will increase the suspension's weight capacity and might make the ride quality a little rougher but it would fit and…

You will measure the MORryde Suspension Upgrade Kit for Tandem Axle Trailers #MR76ZR from the center of each hole on the shackle strap.

Hey Dave, the MORryde upgraded shackle kit part #MR76ZR that you referenced is compatible with your 2020 Grand Design 2670MK and the Lippert Road Armor equalizers.

I can help you figure out how to determine the best option for a wet bolt/shackle upgrade kit, though in order to determine the correct one you will need to take a quick measurement of the shackle straps on your Jayco Jay Flight. The reason for that…

Hey Cody, thanks for reaching out! The wet bolts that come in the MORryde Suspension Upgrade Kit #MR76ZR are Grade 8 Zinc plated bolts, with the thread being 7/16” and the shaft having a 9/16” diameter.

Hey Kevin thanks for your question. There is not much downside to going with the 5,000 lb springs instead of the 3,500 lb. A higher rated spring may make the ride a bit more "chunky" at times, since the spring would not flex as easily.…

Yes, the 2-1/4" Long MORryde Suspension Upgrade Kit item #MR86ZR will lower your trailer's frame closer to the ground. The only effect it will have is to ever so slightly reduce your suspensions travel. The MORryde Suspension Upgrade Kit…

The typical springs for the AL-KO 4,400 axles are one of two lengths. If you have the 25-1/4 inch length, then you will want the 4-Leaf Double-Eye Spring for 5,000-lb Trailer Axles #e28SR, but if you have the 26 inch springs, you will want the 6-Leaf…

The AllTrek 4000 kits provide the best cushioning so if you were to upgrade from your CRE3000 kit to the Alltrek you would see a big improvement. If you have a 35 inch wheelbase you'd want the part #MR29DR or if you have a 33 inch wheelbase…

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

When replacing shackle straps they should be the same length as the ones that were previously on your tandem axle trailer; replacing them with longer straps will result in additional play in your trailer suspension which could lead to additional wear…