How To Measure The MORryde Suspension Upgrade Kit

Question

Question:

How do you measure the shackles? From center of hole to center of hole or the entire length of the shackle?

asked by: Bryan

0

Expert Reply:

You will measure the MORryde Suspension Upgrade Kit for Tandem Axle Trailers # MR76ZR from the center of each hole on the shackle strap.

expert reply by: Bryce D

0

How To Measure Shackle Strap
(click to enlarge)

Answer 1

Hey Beatrice, To find the right fit for your trailer's suspension you'll need to take a quick measurement of your current shackle straps. You'll need to measure from the center of one bolt hole to the center of the other bolt…

view full answer...

Answer 2

I can help you figure out how to determine the best option for a wet bolt/shackle upgrade kit, though in order to determine the correct one you will need to take a quick measurement of the shackle straps on your Jayco Jay Flight. The reason for…

view full answer...

Answer 3

The brackets on the SumoSprings Trailer Helper Springs #SS26MV are 1-1/2" wide so they will fit evenly across the humps on your spring pads. I do not recommend cutting down the spring and you will be able to use these even with only having…

view full answer...

Answer 4

It sounds like you may have one of 2 things going on inside your wet bolts. I have seen some instances where some particles/dirt get inside the wet bolt and clog the weep hole the grease is allowed to pass through. You can remove the bolts not taking…

view full answer...

Answer 5

Yes, the MORryde Suspension Upgrade Kit #MR46ZR that you referenced is correct replacement wet bolt, bushing, and shackle kit for the CRE3000 kit that you have.

view full answer...

Answer 6

The US Manufactured MORryde #MR76ZR Suspension Upgrade Kit for Tandem Axle Trailers is a perfect replacement for your existing bushings, bolts and shackles. The kit is designed for 1-3/4 inch wide leaf spring suspensions, and includes 3-1/8 inch…

view full answer...

Answer 7

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Answer 8

Since your shackle straps are 2-1/4 inch for a wet bolt and heavy duty shackle kit you'd want the #MR46ZR which comes with bushings as well. You do not need new equalizers.

view full answer...

Answer 9

If you are getting inside tire wear on the rear axle of your fifth wheel that would indicate that your trailer is sitting a little nose high and putting additional stress on the rear axle. If you look at your trailer when it's connected to your…

view full answer...

Answer 10

Yes the Suspension Kit for Tandem-Axle Trailers #e99ZR that you referenced can be used with 5,200 lb trailer axles.

view full answer...

Answer 11

The weight of a trailer is transferred evenly by the equalizers to the suspension system(springs, shackles and hangers), and the equalizers do not have a weight capacity listed. The equalizer allows for a smooth transfer of impact caused by rough or…

view full answer...

Answer 12

Thank you for all that info, and replacing the equalizers, as well as upgrading the suspension hardware is going to be the best option for you. The correct size equalizer, as well as the suspension kit that I recommend is the following: - Curved…

view full answer...

How To Measure The MORryde Suspension Upgrade Kit

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching