Kodiak Trailer Hubs and Drums - Hub with Integrated Rotor - KHR10D Review Video

Yes, the DeeMaxx Disc Brake Kit #DE66YR will allow you to use 14" trailer wheels.

The spoke with Dexter and the code "D100G" tells me you have two 10,000 lb trailer axles. I have attached some parts you may need for the axle below. Dexter Trailer Hub Drum Assembly (After July 2009) - part #8-430-5UC3 Dexter Trailer Hub…

Brake calipers are typically installed so they point toward the back of the trailer, but it is okay to install them pointing up or toward the front of the trailer. The important thing to consider when installing the calipers is to make sure at least…

Overpacking the trailer hub with grease is the number one reason for grease seal failure. For a boat trailer I would recommend re-packing the hubs by hand with grease once per season and you'd be fine. I don't like recommending people use…

The DA91 Demco surge brake actuator that you are looking for is part #DM8750311. This has a 2-5/16" coupler, comes with an electric lockout, is designed for disc brakes, and has a weight capacity of 8,000 lbs towing and 800 lbs tongue weight.

Yes, the Hydrastar Vented Electric Over Hydraulic Actuator, #HS381-8067, will work with the factory brake controller on your 2011 Ford F-350. The earlier Ford brake controllers had trouble with these types of system, but Ford changed the brake…

There is a good way to get the check valve out of your current actuator and save some money. What you will need to do is remove the large snap ring from the front of your actuator where the brake line attaches, pull the spring out, and at the end of…

In order to replace your boat trailer surge coupler you will need to match a number of your trailer's characteristics. You need to select a coupler for the type of hydraulic brakes you have, either disc or drum. Couplers for each type vary in…

Thanks for getting me all the info needed to pick out a hub! Based on what you listed the correct hub you need for a replacement is the part #84545BX. This uses the same bearings as what you have and has a matching bolt pattern.

When the L68149 bearing is paired with the L68111 race, the 10-19 grease seal is used. However when the same bearing is used with the L68110 race on a boat trailer, the #168233 seal is usually used. You can verify this by using a digital caliper to…

I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…

The 4-Leaf Slipper Spring w/ Open Eye End for 4,300-lb Trailer Axles - 26-1/4inch Long Item #e33SR that you referenced does not require an additional bushing for the hook end to attach to the rear hanger. The hook end of the spring will rest on the…