Fastway and Diversi-Tech Locking Ball Mounts Adapter Sleeve Review Video

I recommend picking up the Durabilt Safety Chain Connectors for 5/8" Chain #DU55QR for use with your 2021 Chevy Silverado 1500. These have a safe Working Load Limit of 18,100 lbs so they will be able to handle pretty much anything you want…

The B&W Continuum Weight Distribution System part #BW28FR is great for varying loads since you can easily adjust the tongue weight setting. That said, I don't recommend this system when going off-road as it hangs down too low and…

I have attached photos showing the dimensions of the Replacement Sway-Control Bracket #EQ95-01-5600. The larger, L-shaped bracket measures 10 inches long x 2 inches wide and the smaller brackets measure 8-1/4 inches long x 1-1/2 inches wide. These…

An offset stake pocket on your 2021 Ford F-150 has a stake pocket that is biased slightly forward or rearward, not centered. On your vehicle, only the front and middle stake pockets would be offset on your 2021 Ford F-150. If your tie-down anchors…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The Andersen Ultimate Safety Chain Kit with Clevis Hooks #RM3230 that you referenced comes with safety chain tabs that install into open slots on your fifth wheel rails like you can see in the attached picture.

For a general-purpose safety chain for a standard gooseneck trailer we offer #337BSC3842 from Buyers Products. This is a 42-inch chain with 3/8-inch clevis. The chain is rated for 15,000 pounds. This is sold as a single chain, not a pair. The 36-inch…

I attached a set of very detailed instructions for the Andersen safety chain kit part #RM3230 that you referenced. Basically you will have to remove the block that attaches to the king pin of your trailer so that you can remove the two coupler bolts…

Fulton ball mounts, like the #F47CR, are made overseas in China. If you were looking for something American made, you would need to go with something like the Convert-A-Ball #AMSC4. The Convert-A-Ball will have a higher 10,000 pound capacity, the…

It sounds like you'll need to do some fab work in order to get the guide-ons to work. I believe your best bet would be to eliminate the u-bolts and have the brackets welded to the top or the underside of the frame member. If the fender step…

I spoke with my contact at Equal-i-zer who let me know that you should apply 65 foot-pounds of torque on all bolts when installing your replacement sway-control bracket for weight distribution #EQ95-01-5600. If you need a wrench, I would go with the…

If you were to use the 4 inch offset ball #BWGNXA4085 the pin weight on the ball will not be changed. What will change is where the weight is carried on the truck. Using the offset ball will put more weight 4 inches back from the center of the…