Is There A Video Showing How The Fulton Trailer Winch F142400 Works?

Question

Question:

Is there a video showing how this winch works

asked by: Bob G

0

Expert Reply:

I do have a video for the Fulton # F142401 which is nearly identical to the # F142400 that you were looking at. The only difference is that the # F142401 can be used with a strap or wire rope, while the # F142400 can be used with rope only. Other than that they are the same 2K rated 2-speed hand winch. I have linked the video below.

expert reply by: Jesse M

0

Answer 1

We offer boat trailer roller bunks in several sizes that allow you to configure them for the specific total length you need. The linked page displays the 4- and 5-foot sizes we offer from makers like CE Smith and Dutton-Lainson. We have bunks like…

view full answer...

Answer 2

I attached a picture that has all of the mounting hole dimensions of the Fulton winch part #F142400 that you referenced.

view full answer...

Answer 3

My contact at Yates Rubber advises that a nominal 8-inch keel roller does not measure exactly 8 inches; typically they are slightly smaller than the specified size, much the way a piece of 2 x 4 lumber is not exactly 2-inches by 4-inches. I took…

view full answer...

Answer 4

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 5

The size winch that you will need depends on a couple of different factors. I have included part of our hand winch FAQ below regarding boat winches and have linked the FAQ article for you to view. Finding the Right Capacity Winch for your Boat…

view full answer...

Answer 6

The 2-Speed Boat Trailer Winch part #315-W3200D is an excellent upgraded 3,200 lb winch for a boat trailer. In regards to mounting, not all winches use the same pattern so you'd need to compare the dimensions in the photo below to what you have…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Is There A Video Showing How The Fulton Trailer Winch F142400 Works?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching