Dexter Axle Trailer Hubs and Drums - Hub with Integrated Drum - 8-385-81SP Review Video

According to my research, the Dico 15638 Braking Assemblies that you have now are 10" x 2-1/4" therefore the correct replacement for you will be the Hydraulic Brake Kit part #AKUBRK-35-D for single servo or part #AKFBBRK-35-D for…

The thickness of the flat/plate section where the lugnuts mount on the Taskmaster Solid Center Wheel w/ -0.19 Offset - 17-1/2" x 6-3/4" Rim #TA45ZR is .4488 of an inch. Included is a video overview with additional information.

The Westlake 215/75R17.5 Radial Tire w/ 17-1/2" Wheel #LHAS701 does not include the balance beads, or any balancing done when the manufacturer mounts the tire and wheel combination. We do offer the balance beads if you would like to have…

To use the Westlake 215/75R17.5 radial tire and wheel, #LHAS701 is an 8 on 6-1/2 it may be possible to change your studs from 1/2" to 9/16" so long as the studs are drive-in (as opposed to threaded); also, the length and knurl…

When it comes to proper tire pressure for the Westlake 215/75R17.5 Radial Tire w/ 17-1/2" Wheel #LHAS701, you're going to want to always follow what's on the sidewall of the trailer for the maximum tire pressure when…

After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…

I found a Dexter Nev-R-Lube install/removal guide on Dexter's site and they recommend 145 to 155 ft lbs of torque for the spindle nut of a hub with Nev-R-Lube bearings.

In order to remove the hub/drum on your trailer you will want to first remove the spindle nut. Once the spindle nut is removed you are going to want to take a hammer and tap the outer portion of the drum as well as the hub face a few times to break…

You will measure the MORryde Suspension Upgrade Kit for Tandem Axle Trailers #MR76ZR from the center of each hole on the shackle strap.

In order to make sure you get the correct replacement parts you will want to take a measurement or two. It would be best to measure the spring while the trailer is lifted and weight is taken off the spring. You need the eye-to-eye measurement to make…

For a 5,200 lb Lippert axle the correct hub seal is the part #GS-2250DL.

A double lip seal is an upgrade over the single lip that uses a reinforcing spring behind the lip that does a better job of retaining the grease inside the hub and excluding water and road grime. It is perfectly acceptable to use a double lip seal…