Dexter Axle Trailer Hubs and Drums - Hub with Integrated Drum - 8-389-81UC3 Review Video

If you have electric brakes on your 8K axles then you'll need the Brake Kit #AKEBRK-8 along with 2 of the Hub and Drum Assembly #AKHD-865-8-EZ-K per axle. For hydraulic brakes you need the Left #K23-171-00 and Right #K23-172-00 brake assemblies…

The Trailer Hub & Drum Assembly #8-388-80UC3 you were looking at is designed specifically for 42mm Dexter Nev-R-Lube axles and you do not grease any of the components. This hub has sealed bearing cartridges which do not get greased. Now if you…

Trailer hub and drum assembly #8-201-5 does match your bearings. I am fairly certain you have 5,200 pound axles and not 3500 pound axles since all of the parts you need are for higher rated axles than 3500 pounds. The races come already pressed into…

The part that you're looking for is the Dexter Trailer Hub and Drum Assembly for 8,000-lb Nev-R-Lube Axles - 8 on 6-1/2 #DX87XR. This is the same as the part #8-385-81SP that you mentioned with the 9/16" studs except the DX87XR has the…

Dexter Nev-R-Lube Bearings such as the 50MM #31-71-3 referenced in your question do not have a specific maintenance or replacement schedule. These are pre-lubricated at the factory, which will make it resistant to contamination, and sealed for life…

I have confirmed with my contacts at Redline and the manufacturer of this bearing is indeed made by Timken, and that is what you will receive when ordered. This bearing fits the Dexter 50mm Nev-R-Lube axle with 8-lug, 6-1/2 bolt circle. It is…

I spoke with my contact at Dexter regarding the Nev-R-Lube Bearing #31-71-3 that you will be replacing. He stated that you will just need a 1-1/2 inch socket for the 1.42-1.44 inch nut. This is the same size socket needed for a standard spindle nut.

There is a specific procedure for replacing the #31-71-3 Nev-R-Lube bearing, and it is permissible to re-use the spindle nut. The procedure follows below, and I'll also email you a .pdf copy. Jack up the trailer and remove the wheel, then…

To find out what model Dometic AC unit you have you'll need to remove the inside air filter cover and then using a flash light look toward the rear of the unit and on the passenger side of the intake chamber on the AC bulkhead will be a tag. If…

We have the Dexter hub part #8-285-11UC3 which is an 8k trailer hub with an 8 on 6-1/2 inch bolt pattern that uses grease instead of oil bath.

I believe I was able to find the bearings and seals that you need, but you'll want to double check on your end by removing the hub and looking at part numbers just to make sure. Inner Bearing - #25580 Inner Race - #25520 Outer Bearing - #02475…

The bore diameter of the hub part #AKHD-865-8-K that you referenced is 2.722 inches and comes with a grease cap that is designed to fit it. If you were asking this so that you could fit a Bearing Buddy to this hub you would want the part #BB2717SS…