Dexter Axle Trailer Hubs and Drums - Hub with Integrated Drum - 8-219-4UC3 Review Video

It is hard for me to say with absolute certainty, but most likely the part #8-219-4UC3 would work for your 5,200 lb Dexter axle since this hub is designed to fit most 5,200 lb Dexter axles. But the only way to verify this would be to either pull…

Yes, you can upgrade your 24' enclosed trailer's 5,200 lbs axles to 7,000 lbs straight axles. You'll need to upgrade your trailers suspension components, hubs, and wheels/tires. You will want to measure your current axle to…

The two hubs are very similar but the big difference is the size of the seal that comes with the hubs. The #8-219-9UC3-A comes with a seal that has an inner diameter of 2.25 inches and the #8-219-9UC3 comes with a seal that has an inner diameter of…

If you have grease coming out the rear seal, you have a bad seal or the incorrect size seal size. The EZ lube spindles will allow you to see grease out the front with the rear seal intact if your seals are working properly as you stated.…

The Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles - 8 on 6-1/2 - 9/16" Studs #8-219-13UC3 will fit on your Lippert axle. They use the same size bearings and seal.

Yes, you can use the Replacement Switch for Curt Soft Trac I and II Trailer Breakaway Kits #C52010 with your RVI kit.

The Trailer Hub and Drum Assembly #AKHD-865-7-2-K is the same as the Assembly #AKHD-865-7-1-K you found but with 1/2" wheel studs versus the 9/16". We also have the Assembly #AKHD-865-7-2-EZ-K if you need the EZ Lube grease cap to…

Yes, as long as you are installing this on a 7,000 lb axle, you can use these to convert your EZ Lube grease hubs to oil bath hubs. If you aren't sure of your axle size, there should be a tag on the axle with the information or you can just…

The item you selected, while having the right measurements, is not a unitized oil seal. We do carry the 10-63 unitized oil seal (see link). Installing the seal requires pressing the seal flush or slightly into the hub. I normally use a wooden block…

You would know to replace brake shoes the same way you would know with a vehicle. If performance is suffering and adjusting the brakes does not help and there are no other issues causing the poor performance it is probably time to change the brake…

For your first question, I did confirm with Hydrastar that you can use your factory Jayco breakaway switch while using the Electric Over Hydraulic Actuator Kit for Disc Brakes #HBA16-252-82. For wiring your OEM switch, one of the wires will go to…

The Kodiak Disc Brake Kit - 13" Hub/Rotor - 8 on 6-1/2 - Dacromet - 7,000 lbs #K2HRCM1337-9DAC are the correct fit for your 7,000 lb Lippert Axles. They do not come with the bearings or seal, but do come with the races. You will want…