Review of Demco Brake Actuator - 8K Surge Brake Actuator - DM8609101 Video

Yes, you can remove your weld-on coupler and install a new bolt-on coupler that fits a 2 inch ball. There is just a few things you need to do to before and when installing. You need to know what channel size and the weight capacity you will need for…

The best way to determine which hub assembly you will need is by the bearing numbers. The item you selected, Trailer Hub Assembly, part #8-258-5UC1, is a replacement hub which uses Inner and Outer Bearing #L44649. The bearing numbers will be stamped…

We sure do! The Demco Surge Brake Actuator #DM8609101 you were looking at has mounting holes that are 3" apart from the front hole to the second hole, 9-1/2" apart from the second hole to the last hole, and 12-1/2" apart between the…

I looked on Demco's website and was able to pull some information and diagrams on how you would mount the Demco Hydraulic Brake Actuator item #DM8609101. I have attached them below. I was not able to find any pictures of this Actuator installed.…

I have a solution for you to consider, but there are no adapters for a 5-way round. What you can do though is just cut off the 5-way round on your boat trailer and wire in a 5-flat, the 5-Way Flat Trailer Connector #HM47910. Then what you can use for…

I would be happy to help! As long as the A-Frame on your trailer is the standard 50-degree angle then the best option to replace your current surge brake actuator would be the Demco Hydraulic Brake Actuator w Drop - Drum - Primed - A-Frame - 2"…

Yes, you have done your research well. These parts will fit together and allow you to back up without needing anything else. I can confirm that Demco Hydraulic Brake Actuator item #DM8609101 will work with the Hydraulic Trailer Brake Kit - Uni-Servo…

In order to actuate the trailer brakes, you'd need a brake controller installed in the vehicle and a 6 or 7-way trailer connector. A 4 pole flat wiring harness like the #18002 you'd looked at carries 4 circuits- right turn/brake lamp, left…

Electric brakes have 2 wires located at the back. One is for power and the other is for ground (it doesn't matter which is used for which function). The ground wires should be connected to the trailer frame. The only other place that would carry…

If you are referring to two white wires from the brake magnet that are coming from the rear of each electric brake assembly, then it would not matter which wire is connected to ground and which wire is used for the brake feed. The magnet that…

The blue wire is for brake output power to the trailer brakes. One end connects to the brake controller and the other end goes to the pin in the trailer connector on the vehicle side that is for the trailer brakes. The Adapter 6 Pole to 7 Pole…

It sounds like you're looking for a trailer side 5-way connector but your picture is of a 7-way. If you're looking for a 5-way we have part #HM47910 that has a nylon sleeve covering the wires to protect them. I've linked a video for you…