CE Smith Boat Trailer Parts - Roller and Bunk Parts - CE11349 Review Video

For 2 boards that are 2x6 and 96 inches long, I recommend the CE Smith Deluxe Marine-Grade Carpeting for Bunk Boards - Black - 18' Long x 18" Wide #CE11349. This will allow you to cover your boards completely. That will allow better hold to…

Appreciate the photos, they were great, and you are 100 percent right that the correct disc brake kit for you is the 3,500 lb kit from Kodiak: - Kodiak Disc Brake Kit - 10" Rotor - 5 on 4-1/2 - Dacromet #K2R35D The #K2R35D have the right size…

It's not needed to glue the bunk board carpet like #CE11349 as well as staple it. With just staples you'd be fine.

From what I was able to find out with my research is that the ST-36-RH that you've got is the same light as our Optronics LED Tail Light #STL36RB; the replacement lens for the STL36RB can be found using part #A39RB. With that said, Optronics does…

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

The most common way to attach bunk carpet to bunk boards is to use heavy duty staples on the underside of the bunk and then an outdoor carpet adhesive on the tops of the boards. A coworker here used Liquid Nails as an adhesive when he did his two…

We don't sell 2x6 bunk boards, but we do sell the carpet to allow you to wrap boards that are that size. For 2 x 6 bunks you'll want the 18-inch width carpet #CE11349 in order to have full wrap-around coverage without exposed wood.

The general rule of thumb is that you want your bunks to extend completely to the stern (rear) of the boat, or even and inch or two beyond. That way the transom has plenty of support as you drive down the road. The bunks can extend as far forward as…

We typically try to use 1/2 inch stainless steel staples when we install the CE Smith Deluxe Marine-Grade Carpeting, #CE11372, but 3/8 inch staples will work too. I would not go much shorter than the 3/8 inch staples because you don't want them…

Yes, in addition to 2 x 4 bunk boards like #CE27840, we currently offer a few roller bunks. One I recommend is the Dutton-Lainson deluxe roller bunk #DL21741 because of the non-marking rollers. Also, they are galvanized steel (resists corrosion) and…

In the video I attached on re-carpeting boat bunks we used lag bolts to attach the bunks to the hardware. Skip ahead to the 3:00 minute mark to see this.

It sounds like you are looking for bunk board carpeting. The closest we have to your 18 inch by 20 foot is the CE Smith Deluxe Marine-Grade Carpeting for Bunk Boards - Gray - 18' Long x 18" Wide #CE11373 or Black #CE11349. This will give you…