Review of Bright Way Trailer Breakaway Kit - Kit with Charger - 3802311 Video

Yes, the 12 volt accessory circuit of your trailer wiring would be able to keep a 10 amp breakaway kit battery topped off like the part #3802311. Usually the 12 volt accessory circuit of a 7-way is protected with either a 30 amp or 40 amp fuse.

Yes, that all sounds correct. The computer systems on the newer trucks require a constant draw to provide power to the vehicle's 7-Way connector. To work around this you will need the 7-Way Vehicle Power Adapter item #FR87PR. This plugs…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

If you have a break away kit that does not include a charger, you can provide a charge to the battery using the 12 volt circuit or auxiliary circuit from the vehicle 7-Way trailer connector. However, using the 7-Way can overcharge a break away…

The two light illuminations of the light part #BUL603CRB are for a lower intensity red X and a bright white. It's really ideal as a taillight and reverse light. For a similar light that's designed for stop/turn and running light we…

The Tekonsha Push-to-Test Trailer Breakaway Kit #50-85-313 that you referenced includes the small 12V rechargeable battery and charge wires that will be connected to the 12V circuit on the trailer's 7-Way. You could physically use the system with…

The only difference between the 1/2 Inch Lug Nut, #12CLN and #12CLN-L is the length of each. Both are bulge style which means they have a 60 degree tapered end. The inside depth of 12CLN is 1-1/4 inches. The inside depth of 12CLN-L is 1-3/4 inches.

For the clearance light part #AL91RB we have the grommet part #A91GB which is basically a hard rubber.

With plywood walls that are as thin as yours, it's possible that they may not support what you are looking to do. The only way you will be able to utilize the Erickson Horizontal E-Track #EM59150 (2 feet) or #E19148 (5 feet) is by installing it…

On this page (typically below the product links) there is a helpful link section that will have the install instructions fo the Hopkins Breakaway kit part #20400 that you referenced. I also attached an install video that shows the kit installed as…

You likely can use any replacement switch since all they do is complete a circuit when the pin is pulled out. One wire on the switch should be connected to the positive battery terminal on the trailer. The other will tee into the wiring leading from…

Yes, you can use the Hopkins Trailer Breakaway Kit Battery Charger, #20011, with the motorcycle battery on your motorcycle trailer. Like you said, you would simply tie-off the blue wire since it will not be used. This charger will maintain the charge…