Review of Blue Ox Replacement Spring Bar Retaining L-Pins TrackPro, 2-Point - BLU98XR Video

It sounds like you're looking for the spring bar retention bracket for your Reese Pro Round Bar Weight Distribution #RE94FR. The correct replacement is the Replacement Spring Bar Retention Bracket Kit #RP58498.

I reached out to Blue Ox and found that the correct replacement pin for your hitch is the Replacement Spring Bar Retaining L-Pins for Blue Ox TrackPro and 2-Point Weight Distribution - Qty 2 #BLU98XR.

If your new Vanleigh Vilano is equipped with a pre-wired bracket for Furrion Backup Camera Systems like #FOS05TASF then a different brand setup can certainly still be used but it would just require a more intensive hardwired installation. The…

Your Suburban SW6DE takes a 3/4 inch anode rod like the part #CAM11563 which would work well.

I do have an option for you but we don't carry the Lippert PSX2 Stabilizer Jack 695602. Instead, we carry the Lippert High-Speed Power Stabilizer Jack part #LC369774 for a white switch, or part #LC298707 for a black switch. These are very similar…

If your original light is 4" L x 2" W x 1-1/8" D then Optronics light #MC32AB will fit in its place. If you have different dimensions let me know what they are and I can see if we have anything that is a match.

The SAE codes on the lens of a light indicate what function(s) that light can perform. Many trailer lights are designed to do more than one function. Based on the SAE codes on the first light, it performs the following functions: A - Rear reflector…

Yes, the Sway Bracket Jackets for Equal-i-zer Weight Distribution Systems #EQ95-01-5150 you have will work great with the Replacement L-Pins and Clips for Equal-i-zer Weight Distribution Systems #EQ95-01-9430. Attached are a couple of videos for you…

The Replacement L-Pins and Clips for Equal-i-zer Weight Distribution Systems #EQ95-01-9430 that you referenced are confirmed to fit Equal-i-zer and Fastway Weight Distribution (WD) systems but not the Curt TruTrack Weight Distribution System #C17501.…

I was able to go out to the warehouse and check the #EQ37101ET weight distributions for you and I found that they all have the new snap pin like the image of the #EQ95-01-9430 you referenced. The shank that offers a larger drop for the Equal-i-zer…

That is not normal wear for the L-Brackets on your Blue 2-Point #BLU75FR to be that worn. It looks like you have too much angle in the head, so I recommend trying to tilt the L-brackets a little to try and get the bar less on just that one edge, and…

Yes, you should swap the weight distribution bars to the 1,000-lb Spring Bars for Blue Ox TrackPro #BLU52FR. These have a tongue weight capacity of 800-1000lbs. It is important to use the correct bars with the TrackPro since the sway control and…