HitchGrip Weight Distribution 303-HG-712 Review Video

Good morning! To answer your first question, yes the B&W Continuum Weight Distribution System #BW28FR will work very nicely on your Grand Design 2970RL. You are well within the maximum weight parameter of 16,000 lbs, so it will work nicely to…

The B&W Continuum Weight Distribution System part #BW28FR is great for varying loads since you can easily adjust the tongue weight setting. That said, I don't recommend this system when going off-road as it hangs down too low and could create…

If you are still experiencing sag after installing the helper leaf springs, I recommend to use the heavy duty SumoSprings Solo Custom Helper Springs part #SSR-610-47 1,500 lb capacity to help eliminate the sag. The great thing about the Sumo Springs…

If your new Vanleigh Vilano is equipped with a pre-wired bracket for Furrion Backup Camera Systems like #FOS05TASF then a different brand setup can certainly still be used but it would just require a more intensive hardwired installation. The…

It is possible to use a bike rack on a front mount trailer hitch like #31109, but you will want to consider a few things before doing so. First, it could hinder driver visibility, not much, but there is a chance that the top of the bikes will sit…

You are correct, the Curt Front Mount Hitch for the 2010 GMC Sierra, #31109, does not require trimming for installation. I have provided a link to installation instructions and a video installation that you should find helpful. I have also linked a…

The MORryde tray weighs in at 100 pounds. MORryde RV Cargo Sliding Tray - 72" x 20" - 1 Way Slide - 60 Percent Extension - 800 lbs #MR64FR.

The most likely cause of the "no signal" error you are receiving with the Furrion Vision S Wireless RV Backup Camera System part #FOS43TASF is due to an interruption on the camera's power wire. Make sure that the camera is receiving…

The MORryde Sliding Tray for RV Cargo Compartment - 90" x 29" - 800 lbs - 2 Way #MR69FR you were looking at weighs in at 139lbs. This tray has an 800lb weight capacity, and is pretty easy to install as it comes preassembled. I included a…

I went and measured the height of ball #63840 and from the bottom of the base to the top of the ball is 3.16 inches. That is a hair over 3-1/8 inches tall. I have found that this is a fairly common measurement having measured numerous hitch balls…

There isn't actually a maximum weight capacity for the HitchGrip Carrying Tool for Weight Distribution Head Assembly with 2-5/16" Ball #303-HG-712. The only limit is that the hitch ball's neck diameter can be a maximum of 1-5/16" so…

I wasn't able to find much about your Magnetek 6345 power converter but I was able to find out that it has a max 45 amp draw and is rated for AC/DC use which both match the Progressive Dynamics 4000 Series Inteli-Power Converter #PD4045KA. It is…