B and W Fifth Wheel Installation Kit - Custom - BWRVK2600 Review Video

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Yes, we do have a hitch that will fit your 2022 Mercedes-Benz GLB and work with your 2" bike rack. - Stealth Hitches Hidden Rack Receiver #SH69MR This hitch is made in the USA, has a bolt-on, no-drill installation and will provide you with a…

I spoke with a local Dodge technician and he told me that you would have to have the VIN number ran by the dealer to determine if your 2003 Dodge Ram 2500 has overload springs. Apparently what they do is run the VIN and pull up the options. However,…

I have a solution for you, but the Curt Q20 Hitch #C16530-16025 for the 2017 GMC Sierra w/Factory Rail Kit is not compatible with rotating pin boxes like the Reese Revolution and Sidewinder pin boxes. With that said, you can use the Reese M5 5th…

If I follow correctly, you have a 2007 Dodge Ram 2500 with a 6 foot 3 inch box. Our site shows "6-1/2 Foot Bed" and you are concerned about installing the B&W Base Rails, #BWRVK2600. Yes, these install the same as the long bed, 8 foot…

I actually recommend 5th wheel/gooseneck harness #41157 since it is already assembled. You could install it in the bed of a 2014 Ram 2500 with the Ram Box feature. You would just need to install it closer to the end of the bed (unless the Ram Box…

I checked with Kat's and the state that the correct plug to use on your 2004 Dodge Diesel Ram 2500 5.9 liter is the one in the RS position which is on the front corner of the engine block on the driver side.

For a 5th wheel hitch with an under-bed mounting system, the Reese system that includes the #RP30921 sliding Reese M5 5th wheel hitch and the #RP87FR under-bed rail kit would be a good choice for you. You'll want to look under the bed and check…

I checked with Timbren and for your 2016 Toyota Tacoma they recommend the part #TTORTUN4L as a confirmed fit and not the #TTORTUN4. I attached a review video for you to check out as well.

I went out and pulled both the Timbren kit part #TTORTUN4 and #TTORTUN4L from our warehouse to measure them for you and found that they both sit exactly 3-3/4 inches tall.

Suspension enhancement systems like Timbren springs are perfect for the scenaro you're describing. These solutions supplement your factory suspension but don't necessarily increase your capacity. Timbrens are hollow rubber springs that sit…

You are definitely on the right track with the SumoSprings. For your 2021 Toyota Tacoma, I recommend using the SumoSprings Solo Custom Helper Springs - Rear Axle #SSR-612-47. The reason why is because this model of SumoSprings will provide your…