B and W Hitch Ball - Trailer Hitch Ball - BWHB94050 Review Video

Most of the 2-5/16 inch hitch balls will use either a 1-inch diameter shank or 1-1/4 inch diameter shank. The nut size on a hitch ball with a 1-1/4 inch shank, like the Tow Ready 2-5/16 Inch Hitch Ball, part #19286, will use a 1-7/8 inch socket. A…

The back of the Demco A-Frame Trailer Coupler item #12660-97SP is 10-3/8" wide. I have linked a diagram below I made along with a review video.

The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached…

For your Pro Series weight distribution system on your 2012 Dodge Ram 3500, I recommend the Pro Series WD Shank - 14" Long - 4-3/4" or 6-1/2" Drop - 1.5K TW #RP63971. This will account for the 2-3 inches of drop you mentioned whether…

In order to gain additional space between the bumper and the ball I recommend using a ball mount with a long shank. You would not be able to use an extender since the extender will reduce the capacity of the hitch by 50%. We do have one ball mount…

We have the Gen-Y Ball Mount part #325-GH-054 which has 9-1/4 inches from the ball center to the hitch pin hole and has a 16,000 lb weight capacity. It also is a multi ball setup that has a 2 inch and 2-5/16 inch hitch ball.

From the center of the hitch pin hole to the center of the 2-5/16" and 2" hitch balls on the Gen-Y 3-Ball Mount for 2" Hitch Receivers - 2-5/16", 2", 1-7/8" Balls #325-GH-054 measures 9-1/4", and from the center of…

I am happy to tell you that four of the Stake Pocket Tie-Down Anchor - Black Powder Coat - 2" D-Ring - 1,600 lbs #T55B that you ordered will indeed be strong enough to handle the 4,400 lb car you are going to haul. The working load limit (WLL)…

Your weight estimate will be close but probably a bit higher than the 700lb. Of course this is completely dependent on how you load your camper but the largest storage area is the front as well as the bedroom closets and under-bed storage. The Reese…

The tongue weight range of the Curt weight distribution system part #C17063 that you referenced is 1,000 to 1,400 lbs. If you are at 922 lbs you'd be too light for this setup. This would give you a pretty rough ride. The better option is the…

If you have a bench vise you can put a cloth around the ball and use the vise to hold it so you can torque the nut to spec on ball #C40008. Like you said this ball doesn't have wrench flats so there isn't really a better way than using a…

The Gen-Y ball mount part #325-GH-054 actually already has a 2-5/16 inch hitch ball that is rated for 16,000 lb so there would be no need to add another ball in same size. The other ball is a 2 inch ball.