Trailer Hitch Installation - 1997 Ford F-250 - Curt Video

Hey Paul, thanks for reaching out! The bolt holes for the Draw-Tite Class V Trailer Hitch Receiver #DT45502 are spaced out 35-1/2" on center for the width, and then for the back to forth dimensions we're looking at 3-3/8" for the holes…

I checked with Curt and the distance between the vertical mounting flanges of the Curt #C15300 is 33.312 inches.

I spoke with my contact at Curt to obtain the mounting bolt hole locations for the Trailer Hitch Receiver, #C15300 on a 1993 Ford F-150. I have attached a picture to illustrate these measurements. As for repositioning the spare tire, you may need to…

We haven't had the opportunity to obtain video footage of the #31310 front mounted hitch install, but given the to-scale diagram I've provided from the installation instructions, once the hitch is installed the top of the receiver tube will…

Curt Class V hitch #C15300 is a confirmed fit on your 1987 Ford F-150. To help you determine if it will be compatible with your skid plate I went to our warehouse and took a measurement of the hitch to find out the distance from the mounting brackets…

Drilling is required to install Draw-Tite trailer hitch #DT45502 on a 1988 Ford F-250. You will need to drill eight 1/2 inch holes to secure the hitch to the bottom of the vehicle frame. I have included a link to the installation instructions for…

I spoke with my Curt representative, who tells me that the front face of the receiver would sit 10-3/4 inches rearward of the rear-most mounting hole. If you find the rear most mounting hole in the underside of the frame member and measure 10-3/4…

The Draw-Tite Trailer Hitch Receiver #DT45502 for your 1997 Ford F-250 has a dimension of 36-7/8" separating the inside of the mounting plates. The mounting bolt holes are separated by 35-1/2" on center. I have included an image below to…

The fuel tank should not be a problem provided that the bottom of the frame where a hitch like #DT45502 installs is clear on your 1988 Ford F-250. If a hitch were rated right at 10K and the trailer was 10K I do recommend going to a higher capacity…

It looks like you're asking about the B&W Heavy-Duty Trailer Hitch Receiver, part #BWHDRH25122, for your 1996 Ford F-150. You didn't say exactly which dimensions you're looking for but I went out to the warehouse and measured the…

The B and W Hitch part #BWHDRH25122 would fit your 1995 Chevy Silverado 3500 if it was built on a cab and chassis model. Which easy way to determine this is to measure the truck frame from outside to outside. If this measurement is 34 inches then you…

The Buyers Products Class 4 Service Body Short Hitch Receiver #3371801053 has a universal bolt hole mounting pattern. It will fit mounting locations from 28-7/8" to 42-7/8" wide. This Class IV receiver is rated for a maximum tongue weight…