Are The CIPA Custom Towing Mirrors # CM11550 Available With Flat Glass On Drivers Side?

Question

Question:

can i get drivers side mirror in flat glass, you can see further behind !!

asked by: Mark K

0

Expert Reply:

The mirror on the CIPA Custom Towing Mirrors # CM11550 for your 2018 Ford F-150 is only available with the mirror style glass it comes with. You can attach a section of flat mirrored glass on the mirror extension so you will be able to see further behind your vehicle

expert reply by: Bud M

0

Answer 1

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 2

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

view full answer...

Answer 3

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 4

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Answer 5

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 6

My contact at Yates Rubber advises that a nominal 8-inch keel roller does not measure exactly 8 inches; typically they are slightly smaller than the specified size, much the way a piece of 2 x 4 lumber is not exactly 2-inches by 4-inches. I took…

view full answer...

Answer 7

I have added a photo detailing the wiring connections for the Pollack Heavy-Duty, 7-Pole, Round Pin conncetor, #PK11700, see link. This is a SAE J560 compliant connector. The wiring diagram for the vehicle side connector, #PK11720, is pictured also.…

view full answer...

Answer 8

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 9

It sounds like when the Redarc Tow-Pro Elite Brake Controller #RED44FR was installed on your 2022 Toyota Highlander that they may have damaged the brake signal wire or tied into the wrong wire. I recommend taking it either back to the shop who…

view full answer...

Answer 10

To determine if the Replacement Shock for Titan Model 6 and 10 Brake Actuators, part #T1242600 will work to replace your Gabriel number 610712 (T2032) shock, you will need to verify a few quick measurements. Part #T1242600 will work as a replacement…

view full answer...

Answer 11

The different size Equal-I-Zer systems have heads to match the bar sizes so the parts are not interchangeable. But not to worry, with some adjustment you can soften it up a little and not have to use a different system. You will need to lower the…

view full answer...

Answer 12

If the light mounting surface on your older Prowler trailer is not flat enough to allow for use of caulk for sealing the rear of the RV Tail Light #30-92-001 then you might want to use a weather strip tape like #WS1412 which is 1/4-inch thick x…

view full answer...

Are The CIPA Custom Towing Mirrors # CM11550 Available With Flat Glass On Drivers Side?

Product Page this Question was Asked From

Continue Researching