Overall Width and Mounting Hole Bolt Spacing For Curt Trailer Hitch Receiver # C14355

Question

Question:

What is the overall width of this hitch outside to outside of the side rails?

asked by: Bob T

1

Helpful Expert Reply:

The Curt Trailer Hitch Receiver # C14355 is going to be 35-1/2" wide. The more important measurement to look at is going to be the mounting bolt holes. I have included an image below with the mounting bolt hole spacing when measuring on center.

expert reply by: Bud M

1

Mounting Bolt Hole Separation For Curt # C14355
(click to enlarge)

Answer 1

The only differences in the 3 Curt Trailer Hitch Receivers #13355, #C13038 and #13359 for your 1999 Ford F-150 XL Flairside, is the construction and shape of the receiver cross tube and mounting plates. Of these 3 I would choose the Receiver #C13038.…

view full answer...

Answer 2

I had our warehouse measure the Curt Trailer Hitch Receiver #13359 you were looking at and it measures 33-1/2" wide from the center of the left bolt hole to the center of the right bolt hole as shown in the included diagram. I included a link to…

view full answer...

Answer 3

To install the Curt hitch part #13571 the two bolt sizes needed are M12-1.25x40 and M10-1.25x35 which are included. If you need new bolts you can order them from us as part #RHK.

view full answer...

Answer 4

The Curt Trailer Hitch Receiver - Custom Fit - Class V Commercial Duty - 2-1/2" #C15845 will come down about 8 inches from the frame. It does add some support to help with an underrun in a rear end collision so as long as the drop is enough but…

view full answer...

Answer 5

I spoke to my contact at Curt and he sent me a complete dimensional drawing for the Curt Hitch part #C12270 that I attached for you to review.

view full answer...

Answer 6

I was able to get a dimension sheet from my contact at Curt for the Curt Hitch part #C15800 that you referenced. See attached pic. I also attached a set of the installation instructions for this hitch.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 10

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...