Availability of Reese Snap-Up Bracket for Weight Distribution Over 600 Pounds of Tongue Weight

Question

Question:

Is there a replacement bracket like RP21501 that is for a higher tongue weight than 600 lbs.?

asked by: Al V

0

Expert Reply:

Yes, we do have snap up brackets from Reese that go over the 600 lbs limit the # RP21501 has. What you need is the Replacement Heavy Duty Snap-Up Bracket for Reese Weight Distribution Systems # 58392. These brackets are for Reese weight distribution systems with a tongue weight capacity of 800 lbs and over.

expert reply by: Robin H

0

Answer 1

Yes it will, so long as you also use weight distribution, as the extension has a maximum capacity of 3,600 lbs towing/360 lbs tongue weight without weight distribution, but 7,200 lbs towing/720 lb tongue weight when used with weight distribution.…

view full answer...

Answer 2

Those loops you see on the side of the brackets on the #TLA8000 are for the TorkLift GlowGuide Handrail #TLA7621. I attached a picture that shows how the handle attaches to those loops.

view full answer...

Answer 3

The All Terrain Landing Gear #TLA8000 will definitely be the easier of the 2 as far as the installation goes since it's just the foot brackets and then some bolts, washers, and nuts. The TorkLift GlowGuide Handrail #TLA7621 can be installed by…

view full answer...

Answer 4

The TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear - 3 Steps - 25-7/16" Base - 350 lbs #TLA8103 and similar are great steps for replacement options. The biggest consideration is the base measurements of your current steps. You will…

view full answer...

Answer 5

The Replacement Heavy Duty Snap-Up Bracket for Reese Weight Distribution Systems #58392 is a quantity of one replacement bracket, so if you are needing replacement brackets for each side of your trailer you will need to order a quantity of two. I…

view full answer...

Answer 6

To get the correct 4-step replacement for your campers, the most important measurement is going to be the mounting base dimensions, as the widest steps we carry are 24", though the mounting dimensions are wider. For example, the TorkLift…

view full answer...

Answer 7

Thanks for the picture! We do have a replacement option for you. You will want the Replacement Heavy Duty Snap-Up Bracket for Reese Weight Distribution Systems item #58392. This works with Reese weight distribution systems with a tongue weight…

view full answer...

Answer 8

The regular snap-up brackets can bend if the hitch weight is higher than what they are rated for. At 800 to 1,000 pounds, your trailer tongue weight is within the limits of Reese dual-cam systems so it should not be a problem. The heavy duty…

view full answer...

Answer 9

If the snap-up brackets are too far worn on the Strait-Line Weight Distribution System then they will need to be replaced for which we offer the Replacement Heavy Duty Snap-Up Bracket for Reese Weight Distribution Systems part #58392.

view full answer...

Answer 10

If you chose to drill into the frame of your trailer to install the #58392 there are two holes that the bracket has for that purpose. A better deal would be to order the part #RP6637 that is these brackets sold in a pair, plus an additional lift bar.…

view full answer...

Answer 11

The higher capacity Reese WD systems we carry do have the heavy duty brackets part #58392. For example the Reese WD System part #RP66131 has the heavy duty brackets. To answer your other question, yes the #58392 does include the set screw and safety…

view full answer...