Replacement Snap-Up Bracket for Reese Weight Distribution Systems

Question

Question:

I guess the set screw for the snap up bracket on my Dual Cam strait-line W/D hitch came loose, causing the bracket to bend. Is a replacement bracket available? Thank you

asked by: Pat B

0

Expert Reply:

Thanks for the picture! We do have a replacement option for you. You will want the Replacement Heavy Duty Snap-Up Bracket for Reese Weight Distribution Systems item # 58392. This works with Reese weight distribution systems with a tongue weight capacity of 800 lbs and over.

expert reply by: Jerred H

0

Reese Bracket Bent
(click to enlarge)

Answer 1

The higher capacity Reese WD systems we carry do have the heavy duty brackets part #58392. For example the Reese WD System part #RP66131 has the heavy duty brackets. To answer your other question, yes the #58392 does include the set screw and safety…

view full answer...

Answer 2

If you chose to drill into the frame of your trailer to install the #58392 there are two holes that the bracket has for that purpose. A better deal would be to order the part #RP6637 that is these brackets sold in a pair, plus an additional lift bar.…

view full answer...

Answer 3

The Replacement Heavy Duty Snap-Up Bracket #58392 does not require drilling to install as it basically can set on frame members that are up to 2-1/4 inches in width and uses a set screw to secure instead.

view full answer...

Answer 4

If the snap-up brackets are too far worn on the Strait-Line Weight Distribution System then they will need to be replaced for which we offer the Replacement Heavy Duty Snap-Up Bracket for Reese Weight Distribution Systems part #58392.

view full answer...

Answer 5

view full answer...

Answer 6

I cannot recommend you use Blue Ox chain hangers with your Reese weight distribution system. You would need snap up brackets like the part #58392.

view full answer...

Answer 7

To replace the bracket for your Reese Pro Series Weight Distribution system with an 800-lbs tongue weight you'll want to use the Replacement Heavy Duty Snap-Up Bracket for Reese Weight Distribution Systems #58392. This is the bracket for systems…

view full answer...

Answer 8

While snap up brackets like the Replacement Hook Up Brackets for Curt Weight Distribution Systems #C17208 are somewhat interchangeable, I would still recommend using like branded brackets. The Pro Series weight distribution hitches are manufactured…

view full answer...

Answer 9

The regular snap-up brackets can bend if the hitch weight is higher than what they are rated for. At 800 to 1,000 pounds, your trailer tongue weight is within the limits of Reese dual-cam systems so it should not be a problem. The heavy duty…

view full answer...

Answer 10

The Replacement Heavy Duty Snap-Up Bracket for Reese Weight Distribution Systems #58392 is a quantity of one replacement bracket, so if you are needing replacement brackets for each side of your trailer you will need to order a quantity of two. I…

view full answer...

Answer 11

Sounds like you are looking for the thread forming screws that hold the Reese Dual Cam part #RP26002 to the trailer frame which for that you'd need the part #58437 and you'd be set.

view full answer...

Answer 12

9 inches of ground clearance will be adequate for most situations. If you need the drop that the part #17120 provides to tow your trailer level that would be the priority over ground clearance. This shank does not drop down too far so there…

view full answer...

Replacement Snap-Up Bracket for Reese Weight Distribution Systems

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching