Slide Out Toppers For 153" and 79" Slide Outs

Question

Question:

Need part numbers for correct size black toppers. The measurements are 153inches and 79inches outside flange to flange. Have two slides.

asked by: Ronald L

0

Expert Reply:

For your 79" slide out I recommend the Solera RV Slide-Out Awning - 6'7" Wide - 48" Projection - Black Item # LCV000168105.

For the 153" slide out I recommend the Solera RV Slide-Out Awning - 13'1" Wide - 48" Projection - Black Item # LCV000168109.

I recommend using butyl tape item # Item # 344270341411-1 on the brackets to get a water tight seal on your screws.

expert reply by: Kevin C

0

Answer 1

Thanks for the purchase, and you have a pair of options that will fit the Aluminum Liger Trailer Wheel - 15" x 6" Rim - 6 on 5-1/2 - Black #LH49FR: - Lionshead Trailer Wheel Center Cap w/ Snap-In Plug - 4.25" Pilot -…

view full answer...

Answer 2

The center cap you'll want to use with the Aluminum Liger Trailer Wheel #LH49FR is the Lionshead Trailer Wheel Center Cap #LHCS108-SI60C. This is a stainless steel cap with a snap-in plug to make it easier for you to add grease to an…

view full answer...

Answer 3

When measuring the slide out you'll want to measure from outside edge to outside edge of the flanges to get the correct measurement. A lot of times slide outs are close to awnings or doors so you have to account for the overhang of the arms…

view full answer...

Answer 4

I'd be happy to help! For your 2017 Montana 5th Wheel you'll need the following slide-topper awnings: 87-3/4" Slide out: #LCV000163288 for white or #LCV000168106 for black 130-3/4" Slide out: #LCV000163295 for white…

view full answer...

Answer 5

If the fabric on your Solera RV Slide-Out Awning - 6'7" Wide - 48" Projection - White #LCV000163285 is laying loose with no tension you've most likely lost the required amount of tension on your tension springs. You'll want to…

view full answer...

Answer 6

The smallest Solera slide topper that we currently offer is the Solera RV Slide-Out Awning #LC23FR, which fits 60"' wide slide outs. That being said, at 56" you'd still be within the useable range and would just have a bit extra…

view full answer...

Answer 7

The correct Solera RV Slide-Out Awning for an 81" and 84" slide-out is part #LCV000165062 for black or part #LCV000163287 for white. The awning fabric measures 85" long.

view full answer...

Answer 8

We've had this question before and when asked about this Solera has informed us that in order for a slide topper to fit with an awning there needs to be at least 7 inches between the awning and the slide out. If you can let me know the width of…

view full answer...

Answer 9

When picking out a Solera Slide-Topper for your camper you will need to measure the box width on your slide-out. The box width is measured on the outside front of the box, including flange. If the 80 inch measurement you mentioned is your box width,…

view full answer...

Answer 10

It sounds like you are trying to find a slide-topper to fit your slide-out that will not interfere with the adjacent slide-out with slide-topper. If this is the case then the slide-topper you select will need to have fabric that does not cover the…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...