Solera RV Slide-Out Awning Installation - 2019 Keystone Impact 5W Toy Hauler Video

The Solera RV Slide-Out Awning #LCV000165063 is the correct topper for you since it will work on slide outs with a projection of up to 48". There is not one available specifically for 33" projection, but will work just the same and only…

The 6 inches (roughly) is on both ends. So about 12 inches total. There is a little wiggle room if you don't quite have 6 inches when installing a slide-out topper such as #LCV000168105 but not much.

The Equal-i-zer Weight Dist Shank - 2-1/2" Hitch - 10" Rise/6" Drop - 600 to 1,600 lbs TW #EQ90-02-4900 is a great option for a hitch with a 2-1/2 inch receiver and it will step down to fit the e2 system you have perfectly. This shank…

The pre-wiring of Furrion pre-wired RVs is basically just two wires as well as the Voyager harness like part #PSVCWVCMS130AP. One wire is the power wire which is the running light circuit and then the other is the ground so it really would just be a…

We have the perfect solution but the Furrion Vision S W is not compatible with the pre wiring from Voyager. Instead the Voyager WiSight Wireless RV Backup Camera #ASA24YR is the way to go. This will allow you to use the already existing bracket to…

To measure for the correct rise or drop in a weight distribution shank, you want to measure from the top of the trailer hitch receiver to ground (like you did) then measure from the bottom of the coupler of your trailer to ground. If your trailer…

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

According to Solara (Lippert), the correct number of turns to set the proper tension of their slide toppers like #LCV000163285 is between 12 to 16 turns, so I'd consider 14 to be a pretty good happy medium.

I have a solution for you, but my contact over at Lippert tells me that you won't be able to replace just those casings on Solera Slide-Out Topper. The parts you need are the Replacement Idler Head and Roll Tube for Solera RV Slide-Out Awning -…

You are looking for the #LC34FR, which is the replacement Drive Head for a Solera Slide-Out Awning. This will replace your broken driver head and slide into the fabric roller. The Idler Head is available with #LC87FR if you find that also is…

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

Since you need 6 inches of clearance and only have 2.75 inches, there's no reason you couldn't simply use the shorter, 7 foot slide topper #LCV000168105. The trade-off, as you're undoubtedly aware, is that the 7 foot topper is not going…