etrailer Enclosed Trailer Transition Plate Review Video

The etrailer Enclosed Trailer Transition Plate #e32JR will work very well for loading and unloading motorcycles. It has a working load limit of 1,000 lbs so even with your 850 lb bike, you are well within parameters weight capacity wise. Especially…

Here is a list of the tools needed to install the etrailer Enclosed Trailer Transition Plate #e32JR: - Tape Measure - Drill - Hex Drive Socket Adapter - 10mm Socket - 13mm Socket I have also added a link below to the instructions of the #e32JR for…

In regards to the etrailer Enclosed Trailer Transition Plate #e32JR, the end plates are not designed to be swapped. There are pre-drilled holes in the end plates and center plates, which would not line up correctly if the end plates were swapped.…

I verified with the manufacturer for you that the thickness of the RV Vinyl Flooring - Diamond Pattern - 24' Long x 8'2" Wide Strip - Black #TS89FR is .075 inches

The etrailer Enclosed Trailer Transition Plate #e32JR can be used on an open landscape utility trailer, just be sure to use the appropriate mounting hardware for steel since that's what you'll be installing this into. We recommend…

The Charge Wizard on the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger part #PD4575K18LS8 automatically switches voltages while your lead acid battery bank charges. This accelerates the charge but also…

There are a few different brands when it comes to solar power so I recommend finding out exactly which brand of equipment is installed on your RV. You may have an 2-pin XLR style plug in on your camper which would allow you to easily plug in the Go…

We have the Timbren Axle-Less Trailer Suspension System #A35RD545E you can use to replace your current axle. We do not currently carry a traditional axle that matches your dimensions and one would have to be custom made. This system includes all new…

The etrailer Enclosed Trailer Transition Plate #e32JR is 15" long and the width can be adjusted from 48" to 102" using the included hardware and mounting holes.

You should not have a problem mounting the Ventline Vanair Trailer Roof Vent w/ 12V Fan - 6-1/4" Diameter - Smoke, part #VP-543SP, horizontally in your cargo trailer. You will have to make sure it is wired for a fan, if your cargo trailer is not…

Since your 2008 Fleetwood Southwind is built on a Workhorse W24 chassis I believe that there is wiring located up under the dash and to the left of the steering column on the 2006 Workhorse W24 chassis that is for a brake controller. Look for a…

Yes, as you can see in the attached video, the Race Ramps Trailer Loading Assist Ramps part #RR-TR-8 can be used in unison with a trailer ramp door to lessen the approach angle. There is a lip on the end of the ramp that will allow the door to sit…