Replacement Plastic White Fenders for Boat Trailer

Question

Question:

looking for boat trailer fenders for Escort Trailer Bayliner Boat. white plastic 13 inch tires, approx. 43 by 9 inches wide inside spread 30 inch with cutouts for lights, white in color.

asked by: Larry K

0

Expert Reply:

There is a fender which may work for you in the Fulton Single Axle Trailer Fenders with Top and Side Steps # F008574-2.

These are white plastic fenders that are 42-5/8" long x 9-5/8" wide x 12-3/4" tall. They have an 8" wide top step and weight capacity of 300 lbs, though no cutouts for lights.

expert reply by: Kyle S

0

Answer 1

When installing new trailer fenders you don't have to match up the mounting holes perfectly. Typically there is a bit of fabrication needed to install new fenders. What most people do is drill new holes in the fender or some move the brackets on…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 6

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 7

You're correct. The repalcement for your existing B12EA-22 brake would be #AKEBRK-7R-SA for the right side and #AKEBRK-7L-SA for the left.

view full answer...

Answer 8

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 9

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 10

There is a flange on the Tandem Axle Trailer Fenders w/ Backing Plates #HP82VR that overlaps the backing plate that you'll use for the welding surface. When it comes to welding, we always recommend having this done by an experienced welder.

view full answer...