Hitch Recommendation and Rear Fascia Removal for a 2015 Chevy Traverse

Question

Question:

Hi, In the video, the plastic bump cover was not place back. Can this be cut to fit and placed back to cover most of the hitch? Or will it not fit. Thanks

asked by: Joseph P

1

Helpful Expert Reply:

I am sure that with enough trimming you could find a way to be able to reinstall the fascia door of your 2015 Chevy Traverse, but Draw Tite recommends it just simply get removed and not reinstalled when installing the # 75528.

The Curt hitch # 13424 that is also confirmed as a fit for your vehicle has installation instructions that indicate that the panel could be reinstalled if desired on some models

expert reply by: Jameson C

1

Answer 1

I reached out to my contact at Thule and she said for the SSD round side rails on your 2018 Subaru Impreza the Thule Evo Raised Rail Roof Rack that consists of #TH711420 for the two 53 inch WingBar Crossbars in Black or #TH711400 for Silver and…

view full answer...

Answer 2

To install the Thule Hull a Port Pro on Thule Aeroblade crossbars requires the use of the #THXADAPT11 that you mentioned. Otherwise it would not fit on the bars.

view full answer...

Answer 3

I believe the 7-way on your Ridgeline plugs into a US car connector. You can check this by unplugging the damaged 7-way connector from the wiring harness that plugs into the back of it, and comparing what the connector looks like, compared to the…

view full answer...

Answer 4

I looked up the online version of the owner's manual for your 2009 Honda Fit and it says on page 238 that you can flat tow your Honda Fit. I recommend taking a look in your copy of the owner's manual to confirm this and to follow any specific…

view full answer...

Answer 5

Sounds like you are talking about using a single E-Track slot like part #SLSB to instal the Erickson E-Track Tie Down Ring #59131 in a tailgate application like the picture we recieved from a customer who did the same. There isn't an exact…

view full answer...

Answer 6

Installing a trailer hitch like the Draw-Tite hitch, #75662, will not void your warranty on your 2011 Dodge Ram 1500. Consumers of aftermarket products are protected by the Federal Magnusson - Moss Warranty Act. The Act states that if something…

view full answer...

Answer 7

The Rampage Wireless Backup Camera #RA7710 that you referenced is a great option for a wireless camera, since it has the magnetic base it can be mounted in a variety of places around your vehicle or trailer. My contact at Rampage said that you can…

view full answer...

Answer 8

I spoke with my contact at Yakima who said that the MegaWarrior #Y07080 is what you will want to use on your 2014 Honda Pilot. This is 52" long x 48" wide x 6-1/2" tall and will fit your factory crossbars as long as the spread is…

view full answer...

Answer 9

Since you said you want to re-wire your entire trailer I recommend the Optronics Submersible Trailer Light Kit, part #TL5RK. This kit comes with 2 stud-mount lights, 2 amber side marker and clearance lights, a license plate bracket, and a 25 ft…

view full answer...

Answer 10

What you could use is the part #P23507VP. This is normally used for winterizing water tanks but if you wanted to instead pump fresh water in from a container it would work the exact same.

view full answer...

Answer 11

The correct Bearing Kit for your Dexter 3,500 lb torsion axles is for the #84 spindle. This can be found on our site as part #BK2-100. It comes with the Outer Bearing #L44649, Inner Bearing #L68149, and Grease Seal #58846, as well as the appropriate…

view full answer...

Answer 12

We do have exactly what you need, as the SOA567X020 are for some Subarus and are the same as the Thule AeroBlade crossbars. So for the replacement endcaps you will need the following (depending on the one you are missing): - Driver's Side:…

view full answer...