Kodiak Hub Spacer for 11" Rotor - 8 on 6-1/2 - Dacromet - AL-KO 10,000-lb Axles

Video Transcript for Review of Kodiak Trailer Hubs and Drums - KHUBS99A

Today we're going to take a look at the Kodiak Hub Spacer for 11-Inch Rotor on the Al Ko 10000 pound axles, with the eight on six-and-a-half inch bolt pattern. Now this hub spacer fits our Al Ko axle, provides an attachment point for an 11-inch diameter over the hub rotor. This fits a 10,000 pound Al Ko idler axle with the number 99 spindle. Now the rotor that will attach to this, attaches to the spacer, we do sell that separately on our website.This part if made of cast iron. Does include the wheel studs and the industry-standard bearing races right here already pre-installed and one back here. Now the bearings and the seals are sold separately to fit this.

The bearings you will need, the inner bearing part number would be part number 28580. The outer bearing part number would be 25580. And the seal's number would be part number T51153. And all those items we do sell separately on our website, and they're usually listed on this product page as a related product.Again, this application is for disc brakes with the Al Ko axle, a 9,000 pound to 10,000 pound axle. Rotor diameter we mentioned is 11 inches.

The wheel size that will fit on this is 16-inch dual wheels or 17-and-a-half-inch single wheel. The bolt pattern again, right here, is eight on six-and-a-half inches and the wheel stud diameter is five-eights of an inch. But that should do it for the review on the Kodiak Hub Spacer for an 11-inch rotor on the Al Ko 10,000 pound axles with the eight on six-and-a-half-inch bolt pattern.