Lock N Roll 3-Position Adjustable Channel Bracket for 1-1/4" Hitch Receivers - 2,500 lbs

Video Transcript for Review of Lock N Roll Adjustable Trailer Coupler - Adjustable Height Channel Bracket - 336VS507

Hello everybody, this is Jeff at etrailer.com. Today, we're gonna take a look at this Lock 'N' Roll 3-Position Adjustable Channel Bracket for 1 1/4 inch hitch receivers, has a 2,500 pound weight capacity. Now, this channel bracket has three different mounting positions for connecting your adjustable channel mount Lock 'N' Roll vehicle side hitch, which we do sell separately on our website, and it is listed on this product page as a related product. Basically, this shank is what'll slide into your 1 1/4 inch hitch receiver, and it'll secure in place with a pin or a clip. Now, a pin and a clip is not included, we do sell that separately. It does use a 1/2 inch diameter pin, which will fit into this 1/2 inch diameter hole.

Now, this will accept, this channel here will accept the Lock 'N' Roll hitch, the Lock 'N' Roll lunette ring, or the Lock 'N' Roll clevis, which will bolt right into the channel here. Now, just to give you an idea, I happen to pull the Lock 'N' Roll hitch just to give you an idea what that is. And again, I mentioned it is sold separately and listed on this product page. But basically, what you can see is you take these two bolts out here, and this will slide into the channel, and then it gives you an articulating hitch that you can use to hook up to your Lock 'N' Roll system. The bracket, this channel bracket here will let you adjust the hitch height to match different trailers.

The hitch right here when you install it will slide up or down in the bracket, and it secures with the mounting hardware I mentioned that comes with this Lock 'N' Roll hitch. Now, this is a steel alloy construction, very strong and durable, has a nice black paint finish to resist corrosion. This part is made in the USA, and again, the application fits 1 1/4 inch by 1 1/4 inch trailer hitch receivers. Maximum gross trailer weight capacity of 2,500 pounds, tongue weight capacity maximum of 250 pounds. Few dimensions on this, the channel height, channel bracket height, 7 1/2 inches, inside width is three inches, the hole spacing, the four adjustment holes here, if we measure center to center is right at about two inches, and the bolt hole diameter it uses is 5/8 of an inch diameter.

Last measurement I'll give you is from the center of the hitch pin hole to the center of the adjustment hole, 6 1/2 inches. But that should do it for the review on the Lock 'N' Roll 3-Position Adjustable Channel Bracket for the 1 1/4 inch hitch receivers..