Solar Power Kit for TorkLift PowerArmor Battery Box - 10 Watt Panel

See what our Experts say about this TorkLift Accessories and Parts

• Solar Panel Kit Recommendation for Trailer with Battery Box to Maintain Batteries When Stored
  The Solar Power Kit for TorkLift PowerArmor Battery Box # TLA7713 is basically exactly what you are looking for. It was designed to install on a battery box and allow you to put a trickle charge on the batteries as they are stored. I attached a review video for this for you to check out as well.
  view full answer...
• Is Regulator Needed when Installing Solar Power Kit for TorkLift PowerArmor Battery Box
  For your two batteries you would not need to install any type of regulator with the 10 watt solar panel part # TLA7713. This wouldn't put out enough wattage/amperage that it would require regulating for your batteries. The picture I attached shows it wiring directly to a battery.
  view full answer...
  
• How to Wire Tork Lift Solar Panel to Two 12 Volt Batteries
  I have included a picture that shows how you would wire solar panel # TLA7713 to two 12 volt batteries. You will not need any additional regulators or other special wiring since you are using 12 volt batteries. I have also included a link to the installation instructions which is where the picture came from.
  view full answer...
  
• Length of the Power Cable of the Solar Power Kit for TorkLift PowerArmor Battery Box # TLA7713
  I went and pulled the Solar Power Kit for TorkLift PowerArmor Battery Box # TLA7713 from our warehouse and measured the power cords for you. The shorter cable that attaches to the panel directly is 12 inches long and the cable that attaches to the harness and runs to the battery is 38-1/2 inches.
  view full answer...
• Measurements of the Solar Power Kit for TorkLift PowerArmor Battery Box
  I was able to get some measurements of the solar panel # TLA7713 for you. The overall length is approximately 17-1/2 inches. The overall width is approximately 7 inches. And the overall height is approximately 1-1/2 inches. I have linked a video featuring this solar panel for you.
  view full answer...
  
• Solar Panel Recommendation for Charging Deep Cycle Battery Installed on Trailer
  We don't carry fuse panels or deep cell cycle batteries so those two things you'll have to source elsewhere. Basically what you are wanting to do is very possible but it really comes down to you picking out the best battery for your application. Which is going to be the biggest one you can find. We do have a solar panel option we can help with. I recommend the Solar Power Kit from Torklift # TLA7713. This is a 10 watt panel that will maintain the charge to boost the life of your battery...
  view full answer...
• Recommended Solar Battery Charger for Scout Troop Trailer
  For your Scout Troop's new trailer, I recommend taking a look at the TorkLift Solar Power Kit # TLA7713. This will do a great job of continuously charging your trailer battery as long as light is available. The 10 watt panel will maintain a charged battery or can bring a depleted battery back from 50 percent life. If you plan on using the panel with a single battery, you will just need to add the 8-Amp Regulator # TLA7715 to prevent overcharging. I have attached a short video demonstration...
  view full answer...
• Can the Solar Power Kit for TorkLift PowerArmor Be Used Alongside Other Battery Chargers
  The risk that you run of charging your batteries with multiple sources at once is overcharging them. This can also be an issue with a single source but not likely with what you mentioned because I would be willing to bet each of these has built-in protection form overcharging save for maybe the 12 volt pin on the 7-way but this most likely won't provide enough amps for this to occur. In summary, you can us the Solar Power Kit for TorkLift PowerArmor Battery Box part # TLA7713 while also...
  view full answer...
• Using TorkLift Solar Power Kit # TLA7713 with Two 6 Volt Batteries
  The Torklift Solar Power Kit # TLA7713 referenced in your question will work with both 6 volt and 12 volt batteries. You will only need to add an 8-amp regulator # TLA7715 if you are planning on using 4 or more batteries and you are connecting two of the TorkLift Solar Panels. Since you are using two 6 volt batteries, you will not need a regulator. I have attached an image that shows the wiring instructions when using two 6 volt batteries that you might also find helpful.
  view full answer...
  
• Solar Panel Battery Charger Recommendation for Enclosed Cargo Trailer
  A solar panel would work well for you with this application. I recommend the Solar Power Kit from Torklift # TLA7713. This is a 10 watt panel that will maintain the charge to boost the life of your battery and bring a battery back from 50-percent life. We recently installed this solar panel on a trailer to maintain the charge on a battery. I have attached a review and installation video of this solar panel for you. If you plan on using this solar panel with a single battery, you will...
  view full answer...
• Solar Panels on Utility/Cargo Trailer With Option to Expand
  You'd need a battery on your trailer to power the items you mentioned as a solar panel on a trailer would not have enough power for all of them at any given time. You'd want to use a solar panel like the # TLA7713 to charge that battery as needed but it would not be ideal for powering accessories directly. Refrigerators draw quite a bit of amperage so you'd need a decent battery plus possibly additional panels. With the Y-kit part # TLA7714 you can add more. Each of the # TLA7713 panels...
  view full answer...
• Recommendation To Charge The Battery On My Dump Trailer While It Is Hooked Up To My Truck
  I can help you figure out a solution to charging your dump trailer's battery while it is connected to your Silverado. I recommend the Solar Power Kit # TLA7713 to charge your dump trailer's battery. This 8 watt solar panel will maintain the charge and boost the life of your battery. It is important to note that if you are installing this panel on a battery box that contains only 1 battery, you will need a 6-amp regulator # TLA7715 to prevent overcharging. A nice benefit a solar panel...
  view full answer...
• Solar Panel Recommendation for Charging Battery On Trailer
  You could use the Solar Power Kit for TorkLift PowerArmor Battery Boxes # TLA7713 to charge the battery you have on your trailer. This won't plug into a 7-way, but if you wired the output wire to a # 30717 you could make it a quick-disconnect style connection. I attached an install video that shows how we installed one on a trailer.
  view full answer...
• Will Two 12 Volt Marine Batteries Fit in and Be Charged Up By TorkLift PowerArmor Battery Box
  The TorkLift PowerArmor battery box # TLA7708RS has the following internal dimensions: 26-1/2" long x 7-3/8" wide x 12-9/16" tall. You would have to place your batteries next to each other and measure them to determine if both will fit in this box. Provided the batteries are wired as a 12 volt system the solar panel can charge them. But charging 2 batteries will take twice as long. The batteries would need to be at least at 50 percent charge for the solar panel to charge them up. A second...
  view full answer...
• Does TorkLift PowerArmor Locking Battery Box # TLA7708R have Holes In the Lid
  What you are seeing on the lid of TorkLift PowerArmor Locking Battery Box # TLA7708R are not holes. They are like plugs/rivets so if you wanted to install a solar panel, # TLA7713, you would have to pop them out first. I have included a link to the installation instructions for you.
  view full answer...
• Availability of 23-7/8 inch Battery Box with Solar Panel for Trailer
  We have exactly what you are looking for, but the specific part number you are looking for has been discontinued. You will just need the part numbers # TLA7712R and # TLA7713 and you will have the same thing. Check out the demo video I attached as well.
  view full answer...
• Solar Panel and Breakaway System Recommendation for Gooseneck Trailers
  For what you are looking for I think the Solar Panel Kit part # TLA7713 would be a great option to put a maintenance charge on the breakaway batteries of your trailers as they sit for extended periods of time. You will also need the regulator part # TLA7715. I attached an install video that shows the panel being installed on a similar trailer battery. The breakaway system part # 20099 would be a great option to as it has a charger built into it. I attached an install video for this as well.
  view full answer...
• Battery Box and Solar Panel Recommendation for Charging Trailer Battery
  The TorkLift PowerArmor battery box # TLA7708RS has the following internal dimensions: 26-1/2" long x 7-3/8" wide x 12-9/16" tall. You would have to place your batteries next to each other and measure them to determine if both will fit in this box. Provided the batteries are wired as a 12 volt system the solar panel can charge them. But charging 2 batteries will take twice as long. The batteries would need to be at least at 50 percent charge for the solar panel to charge them up. A second...
  view full answer...
• Is the TorkLift PowerArmor DH Locking Battery Box TLA7707 Still Available
  The TorkLift PowerArmor DH Locking Battery Box TLA7707 has been discontinued for a few years but we do have a similar battery box that you can check out. The TorkLift PowerArmor Locking Battery Box # TLA7708R comes with a lifetime warranty and measures Dimensions: 26-3/4" long x 8-3/16" wide x 13" tall. It also has 4 holes that are currently plugged that allow you to install the Solar Power Kit # TLA7713 to help keep your batteries charged. I have linked and installation video for you...
  view full answer...
• Considerations for Choosing Solar Panels and Inverter for 16-Foot Enclosed Trailer
  As you consider your needs and establish your budget for a solar power system for your enclosed trailer I recommend you start with a read of the help articles I have linked for you. A ground-up solar install is a significant undertaking and the best results come with careful planning. If you can budget for an all-inclusive high-capacity set-up, like the Go Power Solar Flex Kit # 34275012, you can avoid the issue of ending up with less power than you need. Careful review of your devices'...
  view full answer...
• Parts Needed to Convert Van to Conversion Van with Solar Powered Components
  To convert your van into a conversion van we do offer a couple of different products in terms of charging your power sources via solar power. I recommend the 10 Watt Torklift Solar Power Kit # TLA7713. This is a solar panel that can be used to charge 12 volt batteries. You can then use a Power Inverter like the Wagan # WC3720, which will convert your 12 volt DC power to 115 volt AC power. AC power is required for the operation and charging of the electronics in your conversion van. I...
  view full answer...
• Can the Torklift Battery Box part # TLA7708 Have 12 Volt Batteries Installed in it with Solar Panel
  The solar panel kit part # TLA7713 will work with both a 6 volt and a 12 volt battery. So yes, you could order the Torklift Battery Box part # TLA7708R and then install the solar panel on it to charge your 12 volt batteries. If you have 4 or more batteries you will need the Y-harness adapter part # TLA7714.
  view full answer...
• How to Charge & Maintain Trailer-Mounted Battery on Dump Trailer
  7-way vehicle wiring can deliver a maintenance charge to keep a charged trailer battery at full charge while you're driving but it will not be able to deliver enough current to re-charge a depleted battery. That will require a shore-power charger like one of the CTEK units, such as # CTEK56353. Another option is a solar panel charger like # TLA7713 which works continuously as long as light is available. For use with one battery you'll also need a 8-amp regulator, part # TLA7715. This...
  view full answer...
• Battery Box Needed That is No More Than 7-3/4 inches Wide
  The TorkLift PowerArmor DH Locking Battery Box TLA7707 that you referenced has been discontinued, but we do have a battery box with similar internal dimensions. The TorkLift PowerArmor Locking Battery Box # TLA7708R has the following internal dimensions: 26-1/2" long x 7-3/8" wide x 12-9/16" tall. As far as the outside dimensions go they are: 26-3/4" long x 8-3/16" wide x 13" tall. This is the smallest battery box that we have which can hold 2 batteries. It also has the option to add...
  view full answer...

Do you have a question about this Accessories and Part?