Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Replace the motor on your standard Lippert electric stabilizer jack system with this Klauber C-800 motor.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we're taking a look at the replacement motor for Electric Stabilizer Jacks. This unit replaces the motor on your standard Lippert Electric Stabilizer Jack system. It includes one Klauber C-800 replacement motor and it does feature a weather resistant design so back here over the motor housing there's a rubberized casing. This protects the motor and keeps out moisture, dirt, and grime. The metal components on the system have a protective finish on them to keep them safe from rust and corrosion. Just keep in mind that this is a replacement motor so it would install the same way as the one that's already installed on your Stabilizer Jack system.
New hardware is not included so you will use your existing hardware. The mount holes, you'll notice that there's four of them, one on each corner right here. If we take a measurement, the distance that we have between each one, and we're just measuring on center, we can see that that's going to give us a measurement of 2 and 5/8 inches. It's a square design so that's the same measurement all the way around between each hole, so 2 and 5/8 by 2 and 5/8 inches, center on center, hole separation.The shaft diameter, that's this portion here, this shaft has a diameter of a half inch. The slot right here on the end is 1/8 of an inch wide by 3/8 of an inch deep and the wiring on the system has a total length from the back of the assembly to the end of the wire casing, that's about 50 inches long.
That's going to do it for today's look at the replacement motor for Electric Stabilizer Jacks.
Average Customer Rating: 4.7 out of 5 stars (41 Customer Reviews)
Replace the motor on your standard Lippert electric stabilizer jack system with this Klauber C-800 motor.I like to replace parts with a product that is known to be dependable and that is why I chose the Klauber C-800. I'm not sure why there is such a difference in priceing between the Klauber and the OEM one that is from a different manufacturer but I went with the best review. I installed this one with little difficulty and it runs extremly quiet compared to the old one which is great. I haven't put it to the test on the road yet but expect I will have trouble free years to come.
The delivery was a bit long in coming and appeared to be the routing in the US that caused the most of it. Once at Canada Post I reveived in three days.
The only problem was in how etrailer packaged the motor. The motor was wrapped with a 8X10 piece of bubble wrap and placed in a box that could have held three motors and shipped. The motor bounced around inside the box punching holes through the sides but thankfully there was no damage done. This is the second shipment that has arrived from etrailer that was poorly packaged. This is the reason for the Average rating.
Part came on the expected delivery date. Only problem was the groove in the drive shaft wouldn’t slip over the pin in the lift assembly, so I had to reem out the groove slightly. Hand grinder solved the issue. Works just like it’s supposed to.
Slot in driveshaft not deep enough, I work in a machine shop. Fixed it.
The guys at e-trailer helped me determine which part number motor I needed and gave me tips on how to install the motor myself. It went exactly as they said it would and I was able to remove the old electric jack motor and install the new one without any issues (and I am not the most mechanically inclined). Jack works perfectly.
Received the replacement motor for my electric jacks within the shipping time specified when I placed the order. The product was easily installed and has been working great for a year now. I recommend etrailer.com for all your RV parts.
Product is better than my original. Steps have been taken to eliminate water infiltration. Serive was exceptional.
Dale D.
6/16/2018
Happy as can be. No moisture issue over winter. Great service great business ethicists.
I want to thank etrailer.com for the handling of my recent order for a C-800 Klauber Motor for the Lippert Electric Stabilizer Jack.
After a small mix up with the shipping address, which resulted in the part being sent back to etrailer from the Canadian warehouse, it was quickly re-shipped by etrailer and arrived at my home within a few days. The part was exactly what I required and after installation it worked perfectly. There were no installation instructions included but with only 4 mounting screws, the removal and installation was not difficult.
The problem with my old unit was exactly as described in your "Ask The Expert" section. Water had entered the motor housing and rusted all the components. It was beyond repair. The motor sits directly behind the rear wheels of my 2011 Flagstaff fifth wheel, so I think road spray from many highway miles must have entered the motor housing. I have included two pictures, one of the "old motor" and one of the "new motor installed".
Installed on rear leveling jack of Rockwood trailer. Replaced a factory motor that was too slow. Works well.
The service I received was great. I ordered over the phone and everything went smoothly. The original Lippert motor that came with the camper only lasted 2 years, I am hoping this replacement motor is of better quality and lasts longer. I would order from etrailer in he future.
So far, so good. When we bought this 2007 Heartland Cyclone Toy hauler, it didn't have a motor on the rear stabilizers. So with your help, we found the right one, got it ordered, received it and now everything is working perfectly!
Thanks!
The motor got here before the delivery date I was given. I installed it, and it works perfectly. My only little complaint is that the wires don't come with the connectors attached, but I knew that when I purchased it.
We had been camping for 7 days. Got ready to leave and our rear levelers wouldn’t raise up. We manually got them up and when I got home I started looking to see what the problem was. It turns out I needed a new motor. I turned to the internet and found etrailer.com. Found my way around their website easy enough and I ordered my replacement motor. It arrived 2 days later, and I was happy it worked. Would use again.
When I ordered the part I was talking to Hayley. She was very helpful in ensuring I was getting the correct part. According to tracking information, my order was processed and shipped within two days. After that it seemed to get bogged down at customs and did take a while to get to me. I did eventually get it, installed it and it works great. Thanks
Shipped fast and worked fine easy insta llation
Installed and worked fine. Good product. Just way overpriced like almost all aftermarket parts and accessories. Too many are same cheap flimsy quality the OEMs use. This not just an etrailer problem.
Great fit, Was able to purchase replacement Stainless Allen Screws from the local hardware store for
a smooth fit. Motor is quieter than the one removed. Price is a lot cheaper than
LIPPERT's motor.
This product worked exactly as I needed it too. This less expensive product replaces the original Lippert systems product and fits perfectly with the original equipment. The problem I had with E trailer.com was they have an option for next day Delivery and it still took three business days to get to me. If I’d known it was going to take that long I would’ve paid $40 less for two day shipping.
Replaced a failed rear jack motor on my 2014 Keystone 5th wheel. Much quieter, faster, and stronger than the factory original. Fit perfect.
This part is so much quieter then the stock one. Installation was simple anyone with simple tools can install this part. My original motor could wake anybody staying next to us if we pulled out early. Would buy again with no hesitation. Its been on a year now and works perfectly.
The motor arrived quickly. Slight damage to one of the threaded mounting holes. Quick repair for that . The rest of the mounting and wiring went as expected. Working fine so far.
Installed new motor. Working great. My RV rear scissor jacks are again working as designed.
This item appears to be a perfect match for the stabilizer system on our camper. However, I will not be able to install it until the spring because the trailer is stored for the winter.
works well only thing I suggest is should be small instructions to tell you to try it before taping wires up never seen camper yet where wires match up right cause wires are switchable to make up / down work as control switch is marked ! motor does work well !!
Clamping world was having a problem getting the motor Googled stabilizing motor and etrailer had the one that looked like it. Watched the video on hole to hole size and shaft size all the same as mine. Very helpful website will order other products in the future..
Fit like a glove and worked perfect, great service and $$price. under $300.00 were every RV dealer was $640.00 plus tax 12%, and everyoe had one in stock. Good place for them in stock. This company was way more fair.
Thank you
Roland W.
7/16/2019
100, works like a dream, thank you
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Doug C.
5/26/2020
I traded in the fifth wheel last fall, but when I did, the jack motor was still working perfectly. very quiet. No issues whatsoever.